Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: obrien135
Showing results 1 to 25 of 205
Search took 0.09 seconds.
Replies: 5
Views: 301
Posted By obrien135

Thank you for the encouragement. It's not so much...

Thank you for the encouragement. It's not so much the complexity of it that's one thing but also I've tried to build about 12 models and I couldn't get any of them to work right. Not so much due to...
Replies: 5
Views: 301
Posted By obrien135

Yes I am way over my head with a lot of these...

Yes I am way over my head with a lot of these questions. I only hope I can figure it out in time to know what direction to go in. I think I am going to give up the hobby
Replies: 2
Views: 264
Posted By obrien135

Thank you for all the information I'm sorry to...

Thank you for all the information I'm sorry to have to tell you that at this point in my development it's a little bit over my head even though I'm not a young man I just found a set of motor and ESC...
Forum: Aerodynamics
05-07-2021, 11:57 AM
Replies: 1
Views: 609
Posted By obrien135

Questions about three channel versus 4 channel and dihedral versus non-dihedral

Hi I have been wondering for a long time why there are no dihedral wings with significant dihedral whatever that means I'm not sure what I mean by that but what seems to be by comparison significant...
Replies: 2
Views: 264
Posted By obrien135

How do I know what size airplane to go with motor

How do I know what size airplane or what weight airplane will work with a 1100 KV 40 amp motor brushless motor?
Replies: 5
Views: 301
Posted By obrien135

How to choose a receiver

I purchased a set of electronics over the internet that includes a propeller and 1100 KV 40 amp brushless motor a brushless ESC I forget what else but it doesn't come with a receiver so I was...
02-23-2021, 12:28 PM
Replies: 2
Views: 509
Posted By obrien135

Will gorilla glue work?

Well gorilla glue work. Does gorilla glue form a strong enough Bond to hold the structural break in the front end of the Traxxas Slash will it be able to take bumps in the road?
02-07-2021, 05:53 AM
Replies: 9
Views: 649
Posted By obrien135

Thank you for your Frank and Ernest reply. I...

Thank you for your Frank and Ernest reply. I guess I would just stick to the gearing I have and enjoy the three s upgrade I already implemented
02-03-2021, 11:12 AM
Replies: 9
Views: 649
Posted By obrien135

Pardon my attitude maybe it's because I've been...

Pardon my attitude maybe it's because I've been on a covid ward for the past week and a half
02-03-2021, 02:45 AM
Replies: 9
Views: 649
Posted By obrien135

When I was an engineer they used to call me Paul...

When I was an engineer they used to call me Paul Bunyan because I figured everything out with a very crude calculator whereas everyone else was using computers and algorithms that were written for...
02-03-2021, 02:44 AM
Replies: 9
Views: 649
Posted By obrien135

I think I'm going to skip the whole thing like it...

I think I'm going to skip the whole thing like it with the airplanes one of the members said that I was trying to hammer a nail with a pair of pliers trying to figure all this out without the right...
02-03-2021, 02:41 AM
Replies: 9
Views: 649
Posted By obrien135

I can't get Google Earth to load on my Obama phone

I can't get Google Earth to load on my Obama phone
02-03-2021, 02:35 AM
Replies: 9
Views: 649
Posted By obrien135

I have the high speed gears that came with the...

I have the high speed gears that came with the brush version that originally bought it's installed in there now. I was told that it would need a higher rate gear rating in order to get 60 MPH which...
02-01-2021, 11:52 AM
Replies: 9
Views: 649
Posted By obrien135

Where can I run my car In branford CT

I have a Traxxas Slash which I upgraded to 3s lipo brushless I was thinking about getting the high-speed gearing but I would need a long stretch of road to bring it up to speed I was wondering if...
01-11-2021, 09:03 AM
Replies: 11
Views: 855
Posted By obrien135

Thank you for your reply. I ended up getting a...

Thank you for your reply. I ended up getting a complete pack with a 4,000 milliamp hour lipo with a 25c rating it's 3s do you think that's sufficient for the 3s power up upgrade is there any way of...
01-11-2021, 01:22 AM
01-11-2021, 01:18 AM
Replies: 4
Views: 550
Posted By obrien135

Left rear tire loosening up

Is solution up of the left rear tire on a traxxas slash two-wheel drive caused by the reverse torque when braking? Is there any way to prevent it?
01-07-2021, 03:54 PM
Replies: 11
Views: 855
Posted By obrien135

Thanks for that information. This evening I...

Thanks for that information. This evening I called the store a hobby store in Connecticut where I live that says they have the completer pack with the lipo and the charger from Traxxas for $90. I...
01-05-2021, 11:08 PM
Replies: 11
Views: 855
Posted By obrien135

What if I get a non Traxxas lipo and the...

What if I get a non Traxxas lipo and the connectors don't match?
01-05-2021, 04:15 PM
Replies: 0
Views: 286
Posted By obrien135

How to pick out a lipo and charger

How to pick out a lipo and charger. I want to purchase a 3s lipo and charger. For a 2wd Traxxas Slash with a power up upgrade what C rating would I need minimally? Would the charger have to be a...
01-05-2021, 04:13 PM
Replies: 1
Views: 331
Posted By obrien135

How to pick out a lipo and charger

How to pick out a lipo and charger. I want to purchase a 3s lipo and charger. For a 2wd Traxxas Slash with a power up upgrade what C rating would I need minimally? Would the charger have to be a...
01-05-2021, 01:51 PM
Replies: 11
Views: 855
Posted By obrien135

Thanks for answering. Actually I upgraded the ESC...

Thanks for answering. Actually I upgraded the ESC and motor today but with the nickel metal hydride battery that I already have it doesn't have much more speed I would like to upgrade to a 3s lipo....
01-02-2021, 11:48 PM
Replies: 11
Views: 855
Posted By obrien135

Thanks I appreciate your input. Actually I'm...

Thanks I appreciate your input. Actually I'm reluctant to do the upgrade unless I can use a 3s lipo because I think that's the only way I can get a drastic change in velocity. And if it's not going...
01-01-2021, 11:30 AM
Replies: 11
Views: 855
Posted By obrien135

So is there any reason at all to go with the...

So is there any reason at all to go with the manufacturer's option?
I I guess a better question is not whether it's foreign or not but whether or not it's the manufacturer's recommended option
12-31-2020, 04:15 PM
Replies: 11
Views: 855
Posted By obrien135

Question about foreign made brushless upgrades

Hi I have been thinking about doing a brushless upgrade for my Traxxas Slash 2wd. I saw a guy with a foreign made ESC and motor on YouTube. It's for$45. That's a lot cheaper than the one from...
Showing results 1 to 25 of 205
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.