Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: Edgar Perez
Showing results 1 to 25 of 500
Search took 0.74 seconds.
Forum: RC Jets
Yesterday, 09:56 AM
Replies: 990
Views: 111,734
Posted By Edgar Perez

I have not done it, but understand you can buy a...

I have not done it, but understand you can buy a third party sensor to use with the cORE to get indicated airspeed.
Forum: RC Jets
05-04-2021, 11:44 AM
Replies: 990
Views: 111,734
Posted By Edgar Perez

There was testing done using the Weatronic...

There was testing done using the Weatronic system, which was the predecessor of the CORE. https://www.rcuniverse.com/forum/fpv-equipment-552/11621458-range-test-few-radio-systems.html
Forum: RC Jets
03-01-2021, 10:24 AM
Replies: 990
Views: 111,734
Posted By Edgar Perez

Hi Anyone have done a flameout alarm with the...

Hi
Anyone have done a flameout alarm with the CORE?
Did you use RPM, Pump voltage, Turbine Status to trigger the alarm?
Thanks
Forum: Marketplace
01-19-2021, 03:42 PM
Replies: 1
Views: 307
Posted By Edgar Perez

Jeti DS-24 / Receivers / CB200 / Sensors

(1) Jeti Duplex DS-24 Carbon Red Wine 2.4GHz/900MHz (including case, charger)
(5) Receiver R3
(3) Receiver 900MHZ
(1) Receiver R12
(1) Receiver R7
(2) CB200
(2) MBAR - Air pressure Sensor
(1)...
Forum: RC Jets
10-15-2020, 03:15 AM
Replies: 558
Views: 61,748
Posted By Edgar Perez

ffffff I did my initial balancing easily enough...

ffffff
I did my initial balancing easily enough with a giant plane balancer like the photo. ...
Forum: RC Jets
09-23-2020, 06:55 AM
Replies: 649
Views: 139,289
Posted By Edgar Perez

I have the thin wheels, but they are ~5.5 inches....

I have the thin wheels, but they are ~5.5 inches. Don't fit in the wheel well without the huge toe-in :confused:
Forum: RC Jets
09-21-2020, 06:27 AM
Replies: 649
Views: 139,289
Posted By Edgar Perez

I think I'm going to finally maiden my CARF SU-30...

I think I'm going to finally maiden my CARF SU-30 next week (bough plane second hand and had to do a lot of fixes..) The plane has 5.5. inch which causes to have excessive toe-in in order to fit the...
Forum: RC Jets
09-14-2020, 06:48 AM
Replies: 558
Views: 61,748
Posted By Edgar Perez

Short update on mine: Went to start the turbines...

Short update on mine: Went to start the turbines (JC Cheetah) and realized that the 4mm main fuel line was putting too much resistance and could not achieve full power. My setup in the fuselage is...
Forum: RC Jets
09-07-2020, 02:51 PM
Replies: 16
Views: 780
Posted By Edgar Perez

I use that one also. No issues. Is not as toxic...

I use that one also. No issues. Is not as toxic as aviation oil. It tints red so you know the fuel already has been mixed.
Forum: RC Jets
09-07-2020, 08:25 AM
Replies: 16
Views: 780
Posted By Edgar Perez

Not sure why, but JetCentral recommend much less...

Not sure why, but JetCentral recommend much less when using 2 stroke synthetic oil for the SE series:
Jet Central recommends using 2 stroke 100% synthetic oil mixed in 1.5% (66-1) to 2% (50-1)...
Forum: RC Jets
09-06-2020, 03:42 AM
Replies: 558
Views: 61,748
Posted By Edgar Perez

Nice, but I will be careful if charging LIPO...

Nice, but I will be careful if charging LIPO batteries inside the plane.
Forum: RC Jets
09-02-2020, 07:33 PM
Replies: 649
Views: 139,289
Posted By Edgar Perez

Single Engine performance ?

Hello
Any experiences with single engine performance? Wondering what to expect if I get a flame-out...
thanks.
Forum: RC Jets
08-25-2020, 01:38 PM
Replies: 274
Views: 92,626
Posted By Edgar Perez

I understand Tomahawk sold some molds to Jet...

I understand Tomahawk sold some molds to Jet Legend. They were already making the Sabre ARF and Rx ready versions. Not sure what planes are involved, but donít think are all of them.
08-24-2020, 09:45 AM
Replies: 13
Views: 1,766
Posted By Edgar Perez

Well, I live in the Caribbean so don't get too...

Well, I live in the Caribbean so don't get too much of temperature changes...
Mines don't really change their values once they get established in the first few runs in the plane. I think the...
08-24-2020, 06:18 AM
Replies: 13
Views: 1,766
Posted By Edgar Perez

I think latest is version 36.37

I think latest is version 36.37
08-21-2020, 12:20 PM
Replies: 1
Views: 1,430
Posted By Edgar Perez

Rhino 200 SE - Shutdowns in flight

Hi Manny or Juan Ramon

Engine stopped while in flight. Checking the log file, only line entry with no data except acceleration error at the end of the flight.
All fuel lines recently replaced and...
Forum: RC Jets
08-13-2020, 05:10 PM
Replies: 26
Views: 1,489
Posted By Edgar Perez

Anurag, I posted a CORE plane program with the...

Anurag,
I posted a CORE plane program with the setup/mixes etc for the individual control of the turbines in here (https://www.dropbox.com/s/kuhiy2teyjn018z/Twin%20Turbines.xml?dl=0). You can use...
Forum: RC Jets
08-13-2020, 06:19 AM
Replies: 311
Views: 63,567
Posted By Edgar Perez

Hi Anyone knows why there is a warning in the...

Hi
Anyone knows why there is a warning in the manual that indicates that a gyro should not be used in the elevators?
It specifically mentions Powerbox Gyro, but assume the warning is for any gyro...
Forum: RC Jets
08-13-2020, 05:15 AM
Replies: 26
Views: 1,489
Posted By Edgar Perez

Not in such nice documentation... lol I will...

Not in such nice documentation... lol

I will take some screen images tonight that should take you there.
Basic concepts are the same;
- one switch/button to select individual turbine control or...
Forum: RC Jets
08-13-2020, 04:56 AM
Replies: 26
Views: 1,489
Posted By Edgar Perez

Attached is how I did it on a Jeti DS-24 soem...

Attached is how I did it on a Jeti DS-24 soem time ago. It worked very well. It was somewhat complex due to a complication on how Jeti produces the servo values when using mixes.
I have since done...
Forum: RC Jets
07-26-2020, 02:07 PM
Replies: 990
Views: 111,734
Posted By Edgar Perez

all except rudder

all except rudder
Forum: RC Jets
07-26-2020, 01:29 AM
Replies: 990
Views: 111,734
Posted By Edgar Perez

itís the same. Attitude assist is the same as...

itís the same. Attitude assist is the same as heading hold in the 3e.
Itís the only mode I fly.
Forum: RC Jets
07-17-2020, 12:32 PM
Replies: 10
Views: 938
Posted By Edgar Perez

I though this was excessive, but itís good to...

I though this was excessive, but itís good to have confirmation.
It was not too hard to isolate. I have three issues to solve:
1- Left elevon- two servos using the Royal servo matching are not well...
Forum: RC Jets
07-17-2020, 07:53 AM
Replies: 10
Views: 938
Posted By Edgar Perez

Max servo acceptable idle current

Hello
I have a CARF SU-30 that has 25 servos in it (!).
What would be an acceptable idle current draw (no controls being moved)?
Mine is drawing around 3.0 amps. I can go ahead and start trying...
Forum: RC Jets
05-25-2020, 03:42 PM
Replies: 558
Views: 61,748
Posted By Edgar Perez

The replacement fan center section as received...

The replacement fan center section as received and found no issues with using the original bearings. They sure are expensive but look good.

https://youtu.be/AiJIpCz_2UQ
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright © 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.