RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: Rogoflap
Showing results 1 to 7 of 7
Search took 0.38 seconds.
08-09-2019, 06:50 AM
Replies: 4
Views: 2,043
Posted By Rogoflap

So I finally found a place Hobbytown that one...

So I finally found a place Hobbytown that one location had one in stock. I purchased it and just received it in the mail. It fit perfectly.

The markings on the engine were the AE emblem and a 15...
08-09-2019, 06:24 AM
Replies: 3
Views: 2,030
Posted By Rogoflap

So I did find some markings on the engine. VX 18...

So I did find some markings on the engine. VX 18 was on there along the engine and the holes on the back plate measure 30MM X 30MM or 42MM Diagnally. So far I have not found any while searching on...
08-02-2019, 09:54 AM
Replies: 4
Views: 2,043
Posted By Rogoflap

I bought this used so no manual was given. I...

I bought this used so no manual was given. I will go with it is stock engine. I have tried a R020 Pull start, but that does not fit as it was a bit too small .

The pull start didn't have any...
08-02-2019, 04:56 AM
Replies: 3
Views: 2,030
Posted By Rogoflap

Nitro Pull Starter Sizes

All,

I have a knock off Nitro about 13 years old. It runs very good. The manual that came with it has part numbers stating a R020 Pull starter for it. When I ordered a few R020 they didn't fit....
08-02-2019, 04:50 AM
Replies: 4
Views: 2,043
Posted By Rogoflap

Older Team Associated 10GT Pull Start

I have an older Team Associated 10GT Nitro. It runs great but currently using a starter box to use it as the pull starter broke a long while back. Now looking to get a pull starter, but
can't find...
Forum: Marketplace
08-05-2018, 05:20 AM
Replies: 0
Views: 526
Posted By Rogoflap

Aquacraft Supervee 27 Nitro Boat

This boat was used maybe 4 or 5 times before moving from a lake area. It is in excellent condition, comes with 27" Boat,
Boat Stand, Decals, Radio. and one extra prop.

General Description of...
08-04-2018, 03:59 PM
Replies: 1
Views: 623
Posted By Rogoflap

18CXP 4 WD Truck, Engine / Exhaust Question

I have a 4wd RC Nitro truck running a 18CXP engine.

The engine has a plastic exhaust, but no way to attach a exhaust tube back to gas tank.

Should it have? if not it is easy for me to create...
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.