Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: Pile-O-Wood
Showing results 1 to 25 of 181
Search took 0.74 seconds.
Replies: 24
Views: 2,314
Posted By Pile-O-Wood

RE: Crappy Spektrum Service Ctr Policy

No problem just buy EFLH1058 from Horzion and replace it.
Replies: 24
Views: 2,314
Posted By Pile-O-Wood

RE: Crappy Spektrum Service Ctr Policy

I have replaced a couple of these ant's, the very small connector is difficult to remove and it is very difficult to reinstall without damaging it or the PCB.
Forum: The Clubhouse
05-22-2008, 03:15 PM
Replies: 12
Views: 2,255
Posted By Pile-O-Wood

RE: tower hobbies shipping prices?

Might be a little thing called !!!!CUSTOMS!!!!
05-05-2008, 07:09 PM
Replies: 0
Views: 172
Posted By Pile-O-Wood

Please answer below post.

I have two of these winging their way to me from Tower but am now very disappointed to hear that the connectors are not in fact the standard JST that I believed they were.

Can you tell me what...
Replies: 69
Views: 5,597
Posted By Pile-O-Wood

RE: Ar6100 receiver Safety

Just remember some people can't find the state of Texas on a map!!
Forum: The Clubhouse
03-26-2008, 09:33 AM
Replies: 7
Views: 769
Posted By Pile-O-Wood

RE: Clubs that has gotten help

Do you own the field? Have you made any improvements to it? If the answer is yes, document it and include with application to AMA.

Have a busness plan to show them what you will use the grant...
Replies: 6
Views: 966
Posted By Pile-O-Wood

RE: DX600i

Go to page 52 of the book and check your power settings. I have seen two DX6I's set to EU power settings out of the box.
01-12-2008, 05:21 PM
Replies: 1
Views: 801
Posted By Pile-O-Wood

DX6I power settings

Danny, I have seen two NIB Blade 400 DX6I radios set to EU power Standards. Are they shipped in this mode??
01-08-2008, 10:30 AM
Replies: 8
Views: 1,460
Posted By Pile-O-Wood

RE: DX6i Questions

Please check the power setting, I saw a brand new blade 400 this weekend and out of the box it was set to the EU standards for power settings. It flew with no problems but it was close in flying....
Replies: 5
Views: 819
Posted By Pile-O-Wood

RE: DX7 Throttle shut-off

Yes, it could be the ECS's low battery monitor causing the shut down. Charge the battery and try again.
Replies: 5
Views: 819
Posted By Pile-O-Wood

RE: DX7 Throttle shut-off

Sounds like the ESC is shuting down due to overcurrent condition.
12-28-2007, 05:29 PM
Replies: 22
Views: 4,057
Posted By Pile-O-Wood

RE: DX-7 ar6100 problem

JMOHN, Three things are certain in life, Death, Taxes and if you fly RC your going to crash. Get with it, and fix your system problem or move on. You have a marginal part in your set up ( not...
Replies: 60
Views: 7,093
Posted By Pile-O-Wood

RE: Spektrum DX7 Ratings from flyers who have used it

JMOHN, Three things are certin in life, Death, Taxes and if you fly RC your going to crash. Get with it and fix your system problem or move on. You have a marginal part in your set up ( not Specktrum...
Replies: 21
Views: 2,248
Posted By Pile-O-Wood

RE: Spektrum Radio Cuts out at 700ft, Crash video included. : )

I had a customer bring in a electric ducted fan jet that had intermittant servo movement problems. Finaly traced it down to servo wires running next to ESC. moved wires and we had no more problems...
Forum: The Clubhouse
12-04-2007, 12:36 PM
Replies: 10
Views: 1,158
Posted By Pile-O-Wood

RE: Anybody played with G4 yet?

The CPU that comes from hobbico has G4 and all the expansion packs installed, and when they come out with a new one, you will get a CD to load the new expansion pack.
Replies: 4
Views: 896
Posted By Pile-O-Wood

RE: Quest about My radio

Go to your LHS and buy an aftermarket wall charger made for JR radios.
Replies: 3
Views: 714
Posted By Pile-O-Wood

RE: futaba 6exh 2.4ghz

Yes and no. You can mix the elevator halves but the trim will only move the master ch.
11-10-2007, 10:24 PM
Replies: 6
Views: 908
Posted By Pile-O-Wood

RE: What is the formula for EXPO ?

He said, (It is probably a parabolic curve Y = AX + BX squared where B is the expo percent and A = 1 - B, or maybe its X cubed. That would give 12 % travel at 50 % stick throw)
09-23-2007, 12:55 PM
Replies: 1
Views: 471
Posted By Pile-O-Wood

9C flap to elevator mix

On a 9C how do I set up a three posistion switch for flaps and mix elevator in all three posistions?
07-17-2007, 05:42 PM
Replies: 6
Views: 1,368
Posted By Pile-O-Wood

RE: Spektrum AR7000 Antenna Separation/Extension

Since most of these are out of stock, can you just make the stock one longer?
Replies: 126
Views: 14,362
Posted By Pile-O-Wood

RE: DX-7 crash

The first company that invents a 100% idiot proof device will make trillions and trillions and trillions.
Replies: 3,148
Views: 327,393
Posted By Pile-O-Wood

RE: Spektrum DX-7

Here's my view on batteries. From reading these posts, and results from customers bringing batteries to the store to be checked out I think some of the problems is improper charging. Example: I had...
Replies: 25
Views: 2,426
Posted By Pile-O-Wood

RE: 6 Volts for speckturm systems?

I've been following these threads for some time, and I think you are wasting your time trying to explain to people about the proper sizing of batterys to people who can't find the state of Texas on a...
Forum: Gas Engines
06-06-2007, 07:08 AM
Replies: 4
Views: 677
Posted By Pile-O-Wood

RE: Gas engine Mount

No mount needed, the 2.4 has a flat mount on the rear of the engine and it does not have a shaft on rear of engine. If you need spacers to get the proper distance from the fire wall to thrust...
Showing results 1 to 25 of 181
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.