RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: Franco2fly
Showing results 1 to 25 of 500
Search took 0.25 seconds.
04-01-2019, 05:50 AM
Replies: 3
Views: 863
Posted By Franco2fly

wierd bar loss

Ever since I started flying my Ventique I've had problems with the TM1000 locking up, but this weekend I went into full test mode. In the lab I see all the correct lights once the Aircraft system is...
06-29-2015, 09:26 AM
Replies: 2
Views: 367
Posted By Franco2fly

See this thread it has a picture ...

See this thread it has a picture
http://www.rcgroups.com/forums/showthread.php?t=2448032
06-29-2015, 08:55 AM
Replies: 2
Views: 367
Posted By Franco2fly

I would use the optical isolator horizon supplies...

I would use the optical isolator horizon supplies and give it a go. You might need to fiddle with the poles setting. If this does not work go with the optical pick up mounted behind the nose cone...
05-17-2015, 08:49 AM
Replies: 1
Views: 1,045
Posted By Franco2fly

WARNING - Telemetry users

I thought that topic might grab your attention. But, I do have a helpful tip for those that use the Spektrum TM1000 and various sensors along with Evolution engines. The scenario goes like this:
...
05-11-2015, 05:20 PM
Replies: 0
Views: 520
Posted By Franco2fly

Binding question

I posted this question in someone else's old thread, and it didn't really get any attention, so I'll start a new thread and see if there's any response.


I have two questions that are highly...
05-05-2015, 11:48 PM
Replies: 2
Views: 684
Posted By Franco2fly

I'm not sure just where to post this but I see an...

I'm not sure just where to post this but I see an answer from the HH team so here goes.

I have two questions that are highly technical and concern Bind. I run 6/7/and 8 channel radios from my...
05-05-2015, 11:22 PM
Replies: 1,367
Views: 104,768
Posted By Franco2fly

Please forgive me for not posting this sooner. ...

Please forgive me for not posting this sooner.

Recently I upgraded my gen 4 iPhone to a new iPhone 6. Apple reps told me that an adapter would be needed to use the STi dongle (32 pin) to the...
01-14-2015, 05:59 AM
Replies: 1,367
Views: 104,768
Posted By Franco2fly

What slot did you assign to GPS? I usually put...

What slot did you assign to GPS? I usually put it at the end of the chain, for instance Altitude/Airspeed/G-force/GPS. Have you tried testing the other sensors? For instance cup your hands around...
01-13-2015, 07:48 AM
Replies: 1,367
Views: 104,768
Posted By Franco2fly

Ok let me address these one at a time. First the...

Ok let me address these one at a time. First the GPS unit. If you read through the directions very carefully, it addresses mounting. Try to keep it text up and as out of the way as possible, I like...
01-09-2015, 11:17 AM
Replies: 1,367
Views: 104,768
Posted By Franco2fly

You know me. I want both while flying

You know me. I want both while flying
01-09-2015, 11:00 AM
Replies: 1,367
Views: 104,768
Posted By Franco2fly

I have pitot tube airspeed but want ground speed....

I have pitot tube airspeed but want ground speed. Did I miss something or
can I get both?
01-09-2015, 09:25 AM
Replies: 1,367
Views: 104,768
Posted By Franco2fly

Sure will be nice to see the updated voice output...

Sure will be nice to see the updated voice output that will speak velocity based on GPS.
Then I will be able to really understand the treacherous downwind turn....

"coming soon"

KKKKFL
10-16-2014, 03:20 AM
Replies: 84
Views: 38,294
Posted By Franco2fly

Thanks for that feedback. I have used it on...

Thanks for that feedback. I have used it on several different ECI's now and it seems to work well. I'm probably just genuflecting by adding the torrid cores, but it can't hurt.

KKKKFL
10-14-2014, 05:22 AM
Replies: 84
Views: 38,294
Posted By Franco2fly

If your DA 150 has an electronic ignition, and...

If your DA 150 has an electronic ignition, and provides the Tachometer lead, use the Isolator (Here is what i found : http://www.horizonhobby.com/ignition...dapter-evoa107...
10-13-2014, 09:18 AM
Replies: 84
Views: 38,294
Posted By Franco2fly

I cut the one off a Dynam ESC then got the micro...

I cut the one off a Dynam ESC then got the micro connector through
about 5 times.

kkkkfl
10-13-2014, 07:33 AM
Replies: 84
Views: 38,294
Posted By Franco2fly

Remember the torrid coil in your test. I'll buy ...

Remember the torrid coil in your test. I'll buy
a pack and send you one in the mail!
10-13-2014, 07:13 AM
Replies: 84
Views: 38,294
Posted By Franco2fly

Len, Since you have a scope, I sure would like...

Len,
Since you have a scope, I sure would like you to check the output line in the configuration that I use.

I use the isolator that HH sells, (Im guessing its an isolator, can't get confirmation...
10-12-2014, 05:42 PM
Replies: 84
Views: 38,294
Posted By Franco2fly

Sound to high. Use another RPM device then adjust...

Sound to high. Use another RPM device then adjust the spectrum
ratio. I think I'm using. 1.1 to 1. But might have that backwards. My DLE has temp sensor stuck
in the first level fins. Temp at idle...
10-11-2014, 02:53 PM
Replies: 84
Views: 38,294
Posted By Franco2fly

That's the ticket guys. And I'll bet Andy you'll ...

That's the ticket guys. And I'll bet Andy you'll
find that it is an optical isolator

kkkkfl
10-11-2014, 11:19 AM
Replies: 84
Views: 38,294
Posted By Franco2fly

http://www.rcuniverse.com/forum/attachment.php?att...

http://www.rcuniverse.com/forum/attachment.php?attachmentid=2039143
I didn't like that first photo, it was out of focus. Here's a better one you can see the micro connector, and also the isolator...
10-11-2014, 11:08 AM
Replies: 84
Views: 38,294
Posted By Franco2fly

http://www.rcuniverse.com/forum/attachment.php?att...

http://www.rcuniverse.com/forum/attachment.php?attachmentid=2039139

Didn't see the coil picture, so here's one on an ESC, I had an old ESC that stopped working so I just cut the lead and then put...
10-11-2014, 10:57 AM
Replies: 84
Views: 38,294
Posted By Franco2fly

http://www.rcuniverse.com/forum/attachment.php?att...

http://www.rcuniverse.com/forum/attachment.php?attachmentid=2039138

The one in my RV-4 is buried, but here's the cable I'm talking about. The electronic ignition for both DLE and Evoloution Gas...
10-11-2014, 08:01 AM
Replies: 84
Views: 38,294
Posted By Franco2fly

On my DLE I use the tachometer lead from the ...

On my DLE I use the tachometer lead from the
ignition module THEN use the isolator that horizon hobby
sells (it comes with their motors so I don't know the part nr
matbe Andy can tell us). This...
09-15-2014, 01:39 PM
Replies: 1,367
Views: 104,768
Posted By Franco2fly

Tks Andy. I do use the STi app but found ...

Tks Andy. I do use the STi app but found
another utility that you might want to check out
its called Spyglass (free version is commander compass)
it is for iPhone use. I can change the units
to...
09-15-2014, 03:20 AM
Replies: 1,367
Views: 104,768
Posted By Franco2fly

Now that I solved the Telemetry lockups by...

Now that I solved the Telemetry lockups by installing a torrid coil, I have a new question. Can a GPS unit be told to report lat/longs in DD/MM/SS instead of DD.xxxxxxxxxx
where x's are 1234567890....
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.