Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: johnfin
Showing results 1 to 18 of 18
Search took 0.09 seconds.
04-24-2020, 06:26 AM
Replies: 0
Views: 301
Posted By johnfin

8.4 nimh

Any of you guys make your own packs and/or really know nimh inside and out?
Forum: Drones Talk
01-08-2019, 01:48 PM
Replies: 0
Views: 332
Posted By johnfin

only 2 props working

my drone was working, no crashes, and now only 2 of the right side props work. other props spin fine by hand. batteries good. any thoughts
Forum: RC Tanks
02-27-2018, 04:21 PM
Replies: 3
Views: 670
Posted By johnfin

charging receiver batteries

Do they make a charging splice cable that connects to the receiver switch so that I can charge the receiver without taking the r/c model apart?
Replies: 8
Views: 601
Posted By johnfin

charging equipment

Do they make a charging splice cable that connects to the receiver switch so that I can charge the receiver without taking the r/c model apart?
Forum: RC Tanks
02-10-2018, 07:27 PM
Replies: 19
Views: 923
Posted By johnfin

Futaba device

Iam looking for a device that connects to a futaba receiver that when a switch or button is pressed on the transmitter, it activates an eletronic switch that could be used to turn on/off an...
Replies: 2
Views: 497
Posted By johnfin

Futaba device

Iam looking for a device that connects to a futaba receiver that when a switch or button is pressed on the transmitter, it activates an eletronic switch that could be used to turn on/off an...
Forum: RC Tanks
01-21-2018, 02:33 PM
Replies: 19
Views: 923
Posted By johnfin

Esc

Also, on this one, 200940131882, is says the output is 7.4 is that at the rated amps. Say i put 9, 10, or 11 volrs into it, will it always be 7.4v
Forum: RC Tanks
01-21-2018, 10:16 AM
Replies: 19
Views: 923
Posted By johnfin

Mixer

If i buy 2 esc's can i use a v tail mixer to get them on one stick?
01-19-2018, 12:44 PM
Replies: 0
Views: 821
Posted By johnfin

Testing 3.7v copter with power supply

DC vs DC. I am trying to test a 3.7v lipo copter with a cd power supply, plenty of amps but it wont work, only with the lipo, What gives?
Forum: RC Tanks
01-16-2018, 05:07 PM
Replies: 19
Views: 923
Posted By johnfin

Cheap

Cheap is right. I was thinking about using 2 of the first one listed with a vtail mixer. If i dont want reverse how about this ebay one:
​​​​​​
112710302453

Its only 9.4 volts though. I need 9.6...
Forum: RC Tanks
01-16-2018, 07:33 AM
Replies: 19
Views: 923
Posted By johnfin

Esc

Which woud be better for a tank:

(2) of these
Ebay 200940131882

Or one of these
Ebay
322155287542
Tank is 9.6 volt powered unsure of amps.
Forum: RC Tanks
01-15-2018, 03:42 PM
Replies: 19
Views: 923
Posted By johnfin

Esc

I have seen some esc's make a high pitch noise all the time. Is this typical with most of them
Forum: RC Tanks
01-15-2018, 06:58 AM
Replies: 19
Views: 923
Posted By johnfin

Esc retrofit

Any of you guys retrotit an esc into a chinese made tank. The electronics went out and i was thinking of getting some cheap esc's on ebay. I have a futaba radio and receiver. Is it just a matter of...
Forum: RC Tanks
01-04-2013, 12:51 PM
Replies: 16
Views: 1,821
Posted By johnfin

RE: RX-18

Where can I get the DBC3?
Forum: RC Tanks
01-04-2013, 10:45 AM
Replies: 16
Views: 1,821
Posted By johnfin

RE: RX-18

I am trying to keep the cost down. I have a bunch of futaba radios and I saw one time that there was a motor controler they could use any TX. My motherboard in the tank seems to be out and I noticed...
Forum: RC Tanks
01-04-2013, 08:03 AM
Replies: 16
Views: 1,821
Posted By johnfin

RE: RX-18

So I could use any 75mhz FM futaba radio to control the RX18?
Forum: RC Tanks
01-04-2013, 07:04 AM
Replies: 16
Views: 1,821
Posted By johnfin

RX-18

Have any of you guys used the hen long RX-18 control board. If so what type of transmitter is used with it?</p>
Forum: RC Tanks
09-17-2012, 12:24 PM
Replies: 1
Views: 570
Posted By johnfin

Tank Conversion

I have some <nobr>cheap (http://www.rcgroups.com/forums/showthread.php?t=1734253#)</nobr> r/c tanks that the control board went out so I am thinking of installing servos and a real radio, problem is...
Showing results 1 to 18 of 18


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.