RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: Jesse Open
Showing results 1 to 8 of 8
Search took 0.01 seconds.
11-01-2022, 04:46 PM
Replies: 1,228
Views: 27,013
Posted By Jesse Open

Lonnie, Are you certain your 220 was fitted...

Lonnie,
Are you certain your 220 was fitted with a steel ring?
09-19-2022, 04:27 PM
Replies: 1,228
Views: 27,013
Posted By Jesse Open

Very well done Lonnie. That twin picked the...

Very well done Lonnie. That twin picked the right " new owner" Good job on the CH box too.
You have a fine combination.
09-02-2022, 11:23 AM
Replies: 1,228
Views: 27,013
Posted By Jesse Open

Ford, Chrysler and a few others have used...

Ford, Chrysler and a few others have used "faractured joint" rods. They need to be very clean at assembly and handled carefully. Joint faces well protected.
08-18-2022, 10:06 AM
Replies: 1,228
Views: 27,013
Posted By Jesse Open

Got it! Looking good, should work very nicely.

Got it! Looking good, should work very nicely.
08-17-2022, 04:32 AM
Replies: 1,228
Views: 27,013
Posted By Jesse Open

Lonnie, Cut and try is fine but how do you plan...

Lonnie,
Cut and try is fine but how do you plan to check the results?
08-16-2022, 09:32 PM
Replies: 1,228
Views: 27,013
Posted By Jesse Open

I understand why you would need the tap. Yessir,...

I understand why you would need the tap. Yessir, we are on the same page.
Especially the "backwards" part, perhaps doing the 1/4" female thread from top side, flip part in collet and cut the 5/16"...
08-16-2022, 11:16 AM
Replies: 1,228
Views: 27,013
Posted By Jesse Open

Do you have the ability to single-point cut the...

Do you have the ability to single-point cut the threads?
With a little bit of calculation, could make indexing reasonably accurate.

BTW, I can loan you 5/16-32 taps in both plug and...
08-15-2022, 05:19 PM
Replies: 1,228
Views: 27,013
Posted By Jesse Open

Lonnie, I see "John_M" has already informed you...

Lonnie, I see "John_M" has already informed you that 5/16 -32 is a standard thread.

Still, you may want to consider having a good lathe operator single point cut the threads.
Due to the root to...
Showing results 1 to 8 of 8


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright © 2022 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.