RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: The Gopher
Showing results 1 to 25 of 61
Search took 0.28 seconds.
Replies: 222
Views: 14,105
Posted By The Gopher

RE: Post your favorite quotes

You gotta be tough when you're dumb -Perry Hawkins PDMC:D
Forum: Gas Engines
04-13-2012, 03:01 PM
Replies: 26
Views: 1,891
Posted By The Gopher

RE: Carb tuning

+1 for Pe +1 for air /fuel =lean/rich fuel=fuel/oil Tune to run do not tune to use fuel as lubricant. if leaned correctly and burns up then oil was too low!
Forum: Aerodynamics
04-03-2012, 09:04 AM
Replies: 125
Views: 13,241
Posted By The Gopher

RE: Maximum altitude??

Food for thought, Imagine the entire uper wing surface as a solar panel
03-11-2012, 04:21 PM
Replies: 61
Views: 5,210
Posted By The Gopher

RE: No more Youtube, engine videos

How did the flying go?????? I let a nice day slide by with intentions of flying and never got it done[&o]
03-08-2012, 01:27 PM
Replies: 45
Views: 2,926
Posted By The Gopher

Forum: Beginners
02-20-2012, 07:58 AM
Replies: 63
Views: 6,529
Posted By The Gopher

RE: Do you remember being a beginner???

Still a begginer but can remember how excited the first flight was. bought a toy a XPV went to parking lot and had a blast next a firebird 3 ch. got boring so a nitro trainer was next got 1 used with...
08-05-2011, 02:40 AM
Replies: 3
Views: 807
Posted By The Gopher

RE: 91AC fuel running out carb and exhaust

Thank you sir, That appeared to be the problem. A little dialing in and be ready for an AM flight
08-04-2011, 11:44 AM
Replies: 3
Views: 807
Posted By The Gopher

91AC fuel running out carb and exhaust

My old 91 ac has been doin fine till today. Last flight I ran it out of fuel in the air. Dead stick was decent. no damage. just didnt have room for a flare, I have landed harder thats for sure,...
07-13-2011, 09:23 PM
Replies: 104
Views: 9,862
Posted By The Gopher

RE: Four Star 60 dies on maiden day.

Kamot. You could have still had a voltage drop internally through vibration or subpar connection. I HAD A SIMILAR MAIDEN DAY with a 300, crash sounded the same . About 45 degress down and the...
08-26-2010, 02:45 AM
Replies: 3
Views: 835
Posted By The Gopher

RE: YS 91 ST runing hot on the High end

Regulator set a tad lean??
08-26-2010, 02:41 AM
Replies: 5
Views: 1,179
Posted By The Gopher

RE: Lost 91 AC muffler, any thread matches?

Hey Bigal. What type of tubing you use to make them? and thanks to the rest of ya also. I have never posted on RCU without getting some help with my problem.
Sometimes I post before I think...
08-13-2010, 09:31 AM
Replies: 5
Views: 1,179
Posted By The Gopher

Lost 91 AC muffler, any thread matches?

Are there any other brands that use the same thread count and pitch as YS I need to pick up a muffler of some type quick. Got a new U-CAN-DO 60 arf waitin for the 91 AC. I've looked for tuner pipes...
07-23-2010, 03:04 PM
Replies: 30
Views: 3,633
Posted By The Gopher

RE: What's your story?

Pheonix models extra 300s, o.s.55ax, spectum dx-6 Bought the plane with the engine installed but not broken in. had been running it some at a tie down station i had built at home and really got it...
03-10-2010, 11:19 AM
Replies: 4
Views: 807
Posted By The Gopher

New YS owner seeks info

My LHS had a 60-u-can-do used RTF with YS 91 $150.00 Needless to say it is mine now. Flies great, awsome power. It is my first four stroke. I looked up enough info to get it started and fly it.
(...
03-02-2010, 10:09 AM
Replies: 1
Views: 461
Posted By The Gopher

RE: charger 4 cycling transmitter batteries

Hello, I've had charger trouble recently and had to buy a new one so I 've got a bunch of different connectors But, Before this last purchase I had to make my own. Just be sure that you use a port...
Replies: 183
Views: 13,665
Posted By The Gopher

RE: Annoying flirting.

Tell her if she wants to win your heart to shower you in R/C stuff:D
03-01-2010, 09:19 AM
Replies: 8
Views: 1,917
Posted By The Gopher

RE: 4s pak 1 dead cell?

Well thought I would update. Thank you guys for the response. I opened up the pak expecting a bad connection but all was well. The #3 cell is just plain dead. I tried a little 5 watt charger I had...
02-25-2010, 12:19 PM
Replies: 1
Views: 538
Posted By The Gopher

RE: LIPO BATTS AND COLD TEMPS?

Howdy, Yes lipos need to be warmed. Learned that the hard way on a hand launch Phase 3 squeel (squall), Came to life after the plane was tore up.
On the 5 cell dents are OK if the pak isn't staying...
02-25-2010, 11:24 AM
Replies: 8
Views: 1,917
Posted By The Gopher

4s pak 1 dead cell?

I have a 4s pak that came off a charger that toasted the next time I used it so I think it only charged 3 of the 4 cells fully. The esc recognized 4 cells that time but after the next charge only 3...
Forum: Sport Flying
02-15-2010, 10:03 AM
Replies: 31
Views: 4,945
Posted By The Gopher

RE: GMS engines

Air bubbles in the fuel line mean you are sucking air in some where. It could be inside or outside of the tank. Inside the tank is where mine usually happens. the line with the clunk on gets alot of...
Forum: Sport Flying
02-13-2010, 07:36 PM
Replies: 31
Views: 4,945
Posted By The Gopher

RE: GMS engines

Howdy neighbor
cold over here in London Oh, tried flying today but old K&B 61 would not run
If your motor won't die it is getting air somehow. has to won't run without it, look for little...
Replies: 5
Views: 5,045
Posted By The Gopher

RE: ElectriFly RimFire 50cc Anyone using?

Man I would like to see that set-up. There are alot of sharp dudes on here. Over in parkflyer/Darkside stryker forum they are all over motors amps etc.
You could try a PM to Moparmyway orGryphon...
Replies: 1
Views: 1,525
Posted By The Gopher

RE: Setting problem with Hacker A50-16s and Phoenix 80

Howdy, If you mean arming the motor try adjusting your travel adjustments on the throttle channel to full open and full closed thats 125% on mine. or the trim setting on the throttle sometimes are...
01-27-2010, 01:51 PM
Replies: 1,955
Views: 214,226
Posted By The Gopher

RE: Official F27 Stryker Part 8: Beginners to Custom Darkness

GREETINGS DARK GODS, I bow before you as I am only dabbling in the fringes of your shadows. I have gazed into your darkness and saw my future there full of smoking electronics and free flowing...
Replies: 2
Views: 671
Posted By The Gopher

RE: Apollo speed control

I'm no expert but I'm pretty sure most escs can be programmed with the controller if you know the sequences. Maybe you'll have better luck than me finding the manual for yours. Mine came in the plane...
Showing results 1 to 25 of 61
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.