RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Search: Posts Made By: fuzion18ss
Showing results 1 to 25 of 47
Search took 0.45 seconds.
07-09-2007, 04:42 PM
Replies: 59
Views: 3,814
Posted By fuzion18ss

RE: Stronger drive shafts for RS4 3?


I'm suprised you aren't chewing up the 45 tooth pinion gear because you have a mismatch.

18 + 45 = 63

23 + 41 = 64

When doing gearing, you want the sum of the first set to...
06-27-2007, 08:16 PM
Replies: 3
Views: 371
Posted By fuzion18ss

RE: MX-3S servo problem

the batteries are probably the cause. The failsafe was probably sensing the loss of signal (or fading signal) from the TX and reacting.
06-26-2007, 05:16 PM
Replies: 3
Views: 371
Posted By fuzion18ss

RE: MX-3S servo problem

I would try removing the failsafe and seeing if the servo still goes crazy.

If it still goes crazy, maybe try removing the VSM.

If that still doesn't work, swap the servos (steering w....
06-26-2007, 04:49 PM
Replies: 28
Views: 1,930
Posted By fuzion18ss

RE: Need some bottom end snap

Which pipe do you have?

Rd Logics turbo II gave my car tons of snap...maybe a little too much (great pipe thx Apollo). I would just spin the tires with the stock gearing. Granted they were...
06-02-2007, 07:53 PM
Replies: 3
Views: 429
Posted By fuzion18ss

RE: is this a good pipe for my 18ss

RD logics Turbo II - it really brought my car to life and i got it on eBay for $45
05-27-2007, 09:21 AM
Replies: 6,263
Views: 507,250
Posted By fuzion18ss

RE: OFFICIAL RS4 RTR 3 thread!!!!!!!Also type SS and others

few vehicle dynamic links:


sounds like lots of oversteer. Also, what is your...
05-19-2007, 01:57 PM
Replies: 8
Views: 812
Posted By fuzion18ss


i've since swapped out the exhaust for a RD logics turbo II
05-09-2007, 07:16 PM
Replies: 605
Views: 58,663
Posted By fuzion18ss

RE: RS4 Club Thread

I've been able to go bashing a little here and there...but lately been plagued with minor problems.

I finally put my RD Logics Turbo II pipe on - that pipe SCREAMS!!!. I was in shock at the...
04-17-2007, 04:07 PM
Replies: 321
Views: 18,144
Posted By fuzion18ss

RE: RS4 18ss and EVO: PROBLEM REPORTS (Official thread)


loosen the glow plug a little (not much) and fire it up that way. Once you remove the ignitor, retighten the glow plug.
04-15-2007, 09:23 AM
Replies: 23
Views: 24,861
Posted By fuzion18ss

RE: Step by Step Procedure on How to Dismantle an Engine

You could check out http://hpiracing.com/walkthroughs/engrebuild.htm but i wouldn't use the pliers like they do.
04-14-2007, 09:24 AM
Replies: 14
Views: 836
Posted By fuzion18ss

RE: Just got my RS4 Evo 3...tell me what you think

how do you like the rd logics failsafe/thermo?
04-14-2007, 01:31 AM
Replies: 104
Views: 28,749
Posted By fuzion18ss

RE: HPI On Road Gallery (All Models)

Finally got around to painting mine. The number plates didn't turn out as well as I would've liked...but lessoned learned from painting 1st body

04-11-2007, 05:33 PM
Replies: 321
Views: 18,144
Posted By fuzion18ss

RE: RS4 18ss and EVO: PROBLEM REPORTS (Official thread)

the spring should depend on the weight of the oil. GYNAIKAS recommends ~15 frt and rr w/ spring or ~45 frt 15 rr w/o
04-03-2007, 04:47 PM
Replies: 4
Views: 506
Posted By fuzion18ss

RE: How do I keep my cars running after startup??

i always start mine w/ the wheels off the ground (can't run away w/ the extra throttle)
03-26-2007, 03:48 PM
Replies: 48
Views: 2,621
Posted By fuzion18ss

RE: RS4 # 18ss kit

I think you're ok, just count the number of teeth on the gear. It should be 38 (according to pg. 6). if you don't have 38 teeth then you know they gave you the wrong gear.

They may not be...
03-20-2007, 05:44 PM
Replies: 17
Views: 950
Posted By fuzion18ss


The best part about the kit is because you built it (every piece, screw, adjustment..etc), when you wreck it's that much easier to fix.
03-20-2007, 05:39 PM
Replies: 4
Views: 400
Posted By fuzion18ss

RE: rs4 18ss is durable

couple of hard hits and i'm impressed with the durability

1st crash: side swipe curb - broke a plastic cap on the adjustable tie-rod (no suprise - it was already partially destroyed from a tire...
03-15-2007, 07:34 PM
Replies: 605
Views: 58,663
Posted By fuzion18ss

RE: RS4 Club Thread

i'd love to play cs...cept someone hacked my cd key and i could never log into steam with it...too pissed that they wouldn't do anything for me to buy another copy (or HL2 for that matter)
03-14-2007, 04:49 PM
Replies: 10
Views: 487
Posted By fuzion18ss

RE: Engine for my RS4

.18 os tz or mod the 18ss

I'd mod the 18ss - buy a spare piston/sleeve assy and go at your current one w/ a dremel. There are threads in the engine forum on what to do
02-22-2007, 10:39 PM
Replies: 605
Views: 58,663
Posted By fuzion18ss

RE: RS4 Club Thread

I finally got to drive my car (18ss) last weekend and toasted first gear
note to self - if the car is rolling backwards, hit the brake, not the gas since the plastic gears will fail long before...
02-21-2007, 07:12 PM
Replies: 10
Views: 651
Posted By fuzion18ss

RE: Question about tower hobbies

all my things were small and I only paid $4 for shipping - ordered it over the weekend and its already been processed and shipped...so I will probably have in the next day or two.
02-19-2007, 08:57 PM
Replies: 55
Views: 4,055
Posted By fuzion18ss

RE: R/C workbench/station

you have nothing to be ashamed of

At least it's climate controlled and there's cold beer 10ft away
02-19-2007, 08:31 PM
Replies: 49
Views: 2,712
Posted By fuzion18ss


a bit more air means you need a bit more fuel (assuming ideal mixtueres)
a bit more fuel means more chemical engry meaning more power

Were there performance gains...quite possibly, but engine...
Showing results 1 to 25 of 47

Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.