Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: Funkerdelicuk
Showing results 1 to 18 of 18
Search took 0.42 seconds.
09-29-2007, 02:57 PM
Replies: 14
Views: 1,246
Posted By Funkerdelicuk

RE: Building board

iv used fiber board used for notice boards
Forum: Beginners
09-29-2007, 02:51 PM
Replies: 19
Views: 1,081
Posted By Funkerdelicuk

RE: new to rc, need help with avistar

you can spend as mutch as you like for feild equipment. its up to you in the end how mutch you want to carry
I would get some kind of box to carry things in.. as your club they may help you get...
Forum: Kit Building
09-29-2007, 02:38 PM
Replies: 8
Views: 832
Posted By Funkerdelicuk

RE: Engine alignment & thrust angle

you need some down thrust on most models.. the side thrust is to alow the tork of the prop when the engine reves.. If you look at your car you can see it pull to one side when you rev it up.. its the...
09-27-2007, 05:00 AM
Replies: 410
Views: 37,218
Posted By Funkerdelicuk

RE: Very Bad Luck

Thank you for the ifo on 40 size phenix funstar 3d. It looks like a good model. I did a serch on google and theres nothing so far in the uk
will cost me 94.66$ for the shiping and 99.99$ for the...
09-26-2007, 04:15 PM
Replies: 410
Views: 37,218
Posted By Funkerdelicuk

RE: Very Bad Luck

I live for 3D What plain is that and do you have a closer photo of it please.. Can I get it in the uk
Forum: Beginners
09-26-2007, 04:13 PM
Replies: 21
Views: 1,728
Posted By Funkerdelicuk

RE: 2.4Ghz

you need to speek to an ortherised radio man to sort this query
09-26-2007, 04:11 PM
Replies: 410
Views: 37,218
Posted By Funkerdelicuk

RE: Very Bad Luck

its a shame that haponed to you. Its comon that 2 planes colidid mid air. there could only be the 2 flying. I had some near misses and tryed to fly lower and get the other pilot to go higher, only if...
Forum: Beginners
09-26-2007, 03:21 PM
Replies: 7
Views: 865
Posted By Funkerdelicuk

RE: Indestructable PRANGSTER for beginers and dearing arobaics

Boosboy. You sed that you did some training on a flight sim. Can you tell me about it please. I considered it and could not make up my mind wether to get one or not, for the winter months to keep my...
Forum: Beginners
09-26-2007, 03:05 PM
Replies: 7
Views: 865
Posted By Funkerdelicuk

RE: Indestructable PRANGSTER for beginers and dearing arobaics

messagge to pkh.. I have no idear if there is a distribitor in the usa. But I no the man that desined it and has sold loads of them.. I will ask him the next time Im on the phone and post his...
09-26-2007, 12:39 PM
Replies: 2
Views: 438
Posted By Funkerdelicuk

RE: Receiver Battery - How Long to Run?

how old are they. If you had them long time you will need to give them a good charge up take them apart and test ech one and see if dead. if you get a torch bulb thats to high voltage like a 6 volt...
09-26-2007, 09:57 AM
Replies: 2
Views: 624
Posted By Funkerdelicuk

RE: Futaba 7C Question

If you get the new futarba FASST 6 chanel set you never have to use cristals again. its the latest and will do planes and hellicopters will cost you about 150. for sevos charger recever switch all...
09-26-2007, 09:53 AM
Replies: 4
Views: 748
Posted By Funkerdelicuk

RE: li-poly charger

you need a LIPRO.PLUS 5 5 IN 1 INTELLIGENT DC BALANCER CHARGER 0.1 TO 5 AP

ONLY THING IS YOU NEED A 12 VOLT BATERY OR TRANCE FORMER TO RUN IT
Forum: Beginners
09-26-2007, 07:33 AM
Replies: 9
Views: 916
Posted By Funkerdelicuk

RE: Another New Member With Plane/Engine Question

i would use ither 40 or 46 2 stroke.. os is not cheep any more. problyt go for abc 46 2 st.. but remember that the modern engines are more powerfull then 20 years ago. so you probly need a bigger...
09-26-2007, 07:28 AM
Replies: 18
Views: 1,632
Posted By Funkerdelicuk

RE: Is a Heat Gun really needed ?

you need a heat gun. it will shrink the covering. use the iron to atach to air frame.. Or you could get some nylon covering. dye it the colour you like. use dope to put on frame. then 1 or 2 coats of...
Forum: Beginners
09-26-2007, 04:10 AM
Replies: 7
Views: 865
Posted By Funkerdelicuk

RE: Indestructable PRANGSTER for beginers and dearing arobaics

Thank you for the warning, on how light it is. I thort it would be on the heavy side, beening made from foam. I look forward in flying this one. I work shifts, so hard to go to my club feild when the...
09-26-2007, 03:14 AM
Replies: 7
Views: 827
Posted By Funkerdelicuk

RE: screws

Sorry Im in to planes and not cars.. But we have simuler problem when you have heave landings. I try to use nut and bolts rather then self tappers, but if i have to, to use a biger size. I have in...
Forum: Beginners
09-26-2007, 02:50 AM
Replies: 7
Views: 865
Posted By Funkerdelicuk

Indestructable PRANGSTER for beginers and dearing arobaics

If you are new to flying rc planes, and want to no the best one to start you off with.. Is the PRANGSTER. It was desined by Robert Newman. The model is made from the same foam thats in car bumpers...
09-26-2007, 02:31 AM
Replies: 7
Views: 827
Posted By Funkerdelicuk

RE: screws

can you send me a link to see. so I try to help you
Showing results 1 to 18 of 18


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.