RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: Got RPM
Showing results 1 to 4 of 4
Search took 0.01 seconds.
07-29-2019, 07:49 AM
Replies: 14
Views: 1,879
Posted By Got RPM

Assuming the transmitter and ESC are correctly...

Assuming the transmitter and ESC are correctly calibrated, if the motor won’t run under any load, then it is most likely damaged or broken. An opportunity to install a more appropriate motor.
07-27-2019, 09:03 AM
Replies: 14
Views: 1,879
Posted By Got RPM

I’m not certain how you calculated amps but it is...

I’m not certain how you calculated amps but it is incorrect. Higher voltage applied to this setup will give higher amps, not lower. You cannot use the motor’s “rated watts” to calculate amps, that...
07-25-2019, 02:35 PM
Replies: 14
Views: 1,879
Posted By Got RPM

It sounds like the ESC is shutting down due to...

It sounds like the ESC is shutting down due to low voltage, with weak packs the inout voltage could be low enough to trigger the LVC, even if fully charged.

My last club ran a similar motor (36mm,...
07-24-2019, 06:36 PM
Replies: 14
Views: 1,879
Posted By Got RPM

Cool The OP has several issues contributing to his...

The OP has several issues contributing to his overheating:

1) He is using the wrong motor, the Kv is too high for 4S, it is more suitable for 3S but still high. A Kv of 1800-2200 would be suitable...
Showing results 1 to 4 of 4


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.