RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: Jesterspeed
Showing results 1 to 8 of 8
Search took 0.06 seconds.
Replies: 762
Views: 190,952
Posted By Jesterspeed

RE: Official HPI E-10 Thread

Got my Yeah Racing steering set, and it was even sloppier than the HPI set. 

Oh well, I did figure out the turning problem...  Sometimes, a noob is a noob.  And you only learn by doing.

But at...
Replies: 762
Views: 190,952
Posted By Jesterspeed

RE: Official HPI E-10 Thread

Ok, found a set of the Yeah Racing aluminum steering linkage on eBay, bought it, and now I am waiting patiently for the package to arrive from overseas...

We'll see how it goes...
Replies: 762
Views: 190,952
Posted By Jesterspeed

RE: Official HPI E-10 Thread

Yah, I have emailed HPI about their upgrade, expressing my dissatisfaction with their product.  But I've checked out the Yeah Racing hop ups and the Atomic as well.

There will be something new on...
Replies: 762
Views: 190,952
Posted By Jesterspeed

RE: Official HPI E-10 Thread

Boy, let's just color me frustrated with my E-10.

Problem? The steering linkage... well, to put it mildly, it blows.

Just consistently doesn't perform even up to the most basic of standards. I...
Replies: 762
Views: 190,952
Posted By Jesterspeed

RE: Official HPI E-10 Thread

Got my bearings set... forgot the damn grease... UGH!  [:@]
Replies: 762
Views: 190,952
Posted By Jesterspeed

RE: Official HPI E-10 Thread

Per HPI Racing, whom I emailed to pose the question, the EN-1 only can handle up to a 21T motor.  Thus the 20T motor would be just a bit too much.

Now, I'm sure I could alleviate some of the heat...
Replies: 762
Views: 190,952
Posted By Jesterspeed

RE: Official HPI E-10 Thread

Thanks for the input people...

So, I can pick up the Saturn 20T for around $20, and add in the new shocks, which - pardon the pun - are shockingly expensive.  Also, I'll upgrade to the bushings to...
Replies: 762
Views: 190,952
Posted By Jesterspeed

RE: Official HPI E-10 Thread

Hello, I'm new to the forum, new to rc cars, but not to modeling or airbrushing. ;)

Got my new E10 Ford GT RTR as a gift, and immediately replaced the drive shaft with the aluminum one, removed...
Showing results 1 to 8 of 8


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.