RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: rcguy!
Showing results 1 to 25 of 500
Search took 0.92 seconds.
09-28-2018, 05:51 AM
Replies: 8
Views: 1,487
Posted By rcguy!

I believe this was a TPO FLITE kit..NOT a SIG...

I believe this was a TPO FLITE kit..NOT a SIG offering.

Dave Rigotti
Forum: Marketplace
08-07-2018, 09:10 AM
Replies: 0
Views: 50
Posted By rcguy!

30cc Cansiter Muffler NEW for Sale

For sale is 1pc 30cc rear dump canister muffler
NEW UNUSED CONDITION
22mm inlet
14mm outlet
50mm diameter
210mm long (50mm section)

NOT SHOWN BUT INCLUDED IS COUPLER PIPE AND SPRING CLAMPS
...
Forum: Marketplace
08-07-2018, 09:07 AM
Replies: 0
Views: 87
Posted By rcguy!

MTW TDH45 Rear Dump Canister Muffler

For sale is 1pc USED MTW TDH45 rear dump canister muffler
22mm inlet
15mm outlet
52mm diameter
280mm long (52mm section)

NOT SHOWN BUT INCLUDED IS COUPLER PIPE AND SPRING CLAMPS

ConUS...
Forum: Marketplace
07-18-2018, 09:24 AM
Replies: 0
Views: 366
Posted By rcguy!

Hangar 9 Piper Cub ARF HAN4000

For sale is 1pc Hangar 9 Piper Cub ARF HAN4000. 90% assembled with pushrods and control horns installed, tail brace wires, engine mount, assembled fuel tank, and landing gear installed. Just add...
Forum: Marketplace
07-10-2018, 07:20 AM
Replies: 0
Views: 319
Posted By rcguy!

Great Planes Giant Big Stik with DLE30 less RX

For sale Great Planes Giant Big Stik 80.5" wing span in good condition weighing 14 pounds. Equipped as follows:
DLE30cc engine with @3 gallons 32:1 gas through it
MTW TDH45 canister muffler
6pcs...
Forum: RC Jets
02-27-2018, 07:13 PM
Replies: 4,490
Views: 729,947
Posted By rcguy!

Anyway..... Move the turbine forward an 1"...

Anyway..... Move the turbine forward an 1" (25.4mm) and you need less nose weight. THAT alone will more than make up for any perceived loss in turbine performance. BTW...she'll fly fine at 170MPH...
Forum: RC Jets
02-26-2018, 06:45 AM
Replies: 4,490
Views: 729,947
Posted By rcguy!

Build it stock per plans. Fully sheet the wing if...

Build it stock per plans. Fully sheet the wing if your Monokote scheme dictates it. Yes you'll add weight to the very nose...BUT even at 18 pounds+ the JC 60 will push it along VERY nicely AND she'll...
Forum: RC Jets
02-26-2018, 06:40 AM
Replies: 4,490
Views: 729,947
Posted By rcguy!

How ya doin' Mark! STILL love the R54 and check...

How ya doin' Mark! STILL love the R54 and check in every so often!

Dave Rigotti
Forum: RC Jets
02-25-2018, 07:44 PM
Replies: 4,490
Views: 729,947
Posted By rcguy!

You can straighten out the cable sheath by...

You can straighten out the cable sheath by inserting a piece of music wire in it ( 1/16"?) and passing a heat gun over it for a few minutes. Allow to cool completely. Might take a few tries....
...
Forum: ARF or RTF
12-15-2017, 06:08 PM
Replies: 763
Views: 136,788
Posted By rcguy!

Smile Just finished up MY version of the Giant Big...

Just finished up MY version of the Giant Big Stik! The DLE30 uses the stock aluminum mounts. I got a header and canister muffler off of ebay that weighs 4 oz more than the stock one. I moved the...
Forum: ARF or RTF
11-28-2017, 06:15 PM
Replies: 763
Views: 136,788
Posted By rcguy!

Rudder Pull Pull

I see ALOT of recommendations on moving the rudder servo forward and using pull-pull to help with the tail heavy condition when using a DLE30.
Can anyone who has done this post some pictures of...
Forum: ARF or RTF
11-23-2017, 11:02 AM
Replies: 763
Views: 136,788
Posted By rcguy!

Has anyone put floats on their Great Planes...

Has anyone put floats on their Great Planes Giant Big Stik?

Dave Rigotti
Forum: ARF or RTF
11-10-2017, 05:30 AM
Replies: 365
Views: 36,389
Posted By rcguy!

Thank you! Dave Rigotti

Thank you!

Dave Rigotti
Forum: ARF or RTF
11-10-2017, 05:29 AM
Replies: 365
Views: 36,389
Posted By rcguy!

Thank You! Was a neat project to do. VERY...

Thank You! Was a neat project to do. VERY quite. I measured 79db at
9 feet from it on a hard surface at WOT. Other club members remarked on it too.

Dave Rigotti
Forum: ARF or RTF
11-09-2017, 07:44 PM
Replies: 365
Views: 36,389
Posted By rcguy!

Smile She's done. 13# 12oz with DLE header and canister...

She's done. 13# 12oz with DLE header and canister muffler. Flew it 2 flights today despite some stronger winds than I like. All went well. It REALLY scoots along on the Xoar 19/8 prop. Lands slow...
Forum: ARF or RTF
10-16-2017, 06:03 PM
Replies: 365
Views: 36,389
Posted By rcguy!

I'm seriously considering getting a Escapade MX...

I'm seriously considering getting a Escapade MX 30cc. Our field is sensitive to noise so I MUST use a canister type muffler

I ask if anyone can measure the distance between the bottom of the wing...
Forum: ARF or RTF
10-15-2017, 03:07 AM
Replies: 365
Views: 36,389
Posted By rcguy!

Tom, I think you misunderstood my...

Tom,
I think you misunderstood my question.......

I'm not asking about the muffler that comes with the engine. I'm asking about the after market canister muffler DLE offers here:
...
Forum: ARF or RTF
10-14-2017, 05:58 PM
Replies: 365
Views: 36,389
Posted By rcguy!

Here's a question for ya.... Has anyone used...

Here's a question for ya....
Has anyone used the DLE 35cc canister muffler setup with the DLE35RA in the Escapade MX 30-35cc? Our flying field is VERY sensitive to noise......
Thanks
Dave Rigotti
Forum: RC Jets
07-07-2017, 07:01 AM
Replies: 4,490
Views: 729,947
Posted By rcguy!

With 60* flap deflection (as recommended by...

With 60* flap deflection (as recommended by Bruce) only drag is created, no additional lift. The wing has plenty of "lift" even at slow speed, thus the NEED for DRAG to land with the high residual...
Forum: RC Jets
07-07-2017, 06:15 AM
Replies: 4,490
Views: 729,947
Posted By rcguy!

Cool The flaps are used to create drag, not increase...

The flaps are used to create drag, not increase lift. With full flap deflection, you'll need about 1/3 throttle just to maintain slow flight with the wheels out. NO NEED FOR SPEED BRAKES!
04-15-2014, 04:24 AM
Replies: 19
Views: 2,311
Posted By rcguy!

The lighter, the better! Nothing else to say.....

The lighter, the better! Nothing else to say.....
03-08-2014, 04:35 PM
Replies: 215
Views: 24,104
Posted By rcguy!

No name on the email? Contact number? Pure BS. ...

No name on the email? Contact number? Pure BS. These folks are crooks.....

Dave Rigotti
07-10-2013, 01:12 AM
Replies: 21
Views: 2,592
Posted By rcguy!

RE: Citation Kit is here!

Amen brother Tony! Enjoy the build my friend.

Dave Rigotti
10-10-2012, 01:47 PM
Replies: 20
Views: 2,255
Posted By rcguy!

RE: Remember these Guys

Gotta love those B&W TV's!

Dave Rigotti
Forum: RC Jets
06-26-2012, 05:26 PM
Replies: 26
Views: 3,979
Posted By rcguy!

RE: My Over Reaction!

No to Ky. Family stuff got in the way for Titusville. Now back on topic.....

Dave
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.