RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: barry wetherell
Showing results 1 to 25 of 66
Search took 0.39 seconds.
03-16-2015, 04:57 AM
Replies: 1
Views: 426
Posted By barry wetherell

14sg updates

HI all, well the 2 updates I wish to configuer on the tx is rather annoying, I have downloaded the updates, onto my laptop, Ok they need to unzipped.... done but when I try to load them onto my SD...
Replies: 14
Views: 1,478
Posted By barry wetherell

Guys, I have just been given a 12fgh, but I fly...

Guys, I have just been given a 12fgh, but I fly airplanes , can I change the default to aircraft ?????
Barry
06-27-2014, 04:08 PM
Replies: 91
Views: 28,192
Posted By barry wetherell

Hi guys, very interesting read, this thread, I...

Hi guys, very interesting read, this thread, I have had an Al Masters plan reduced from 81 to 73, and going electric, My thoughts in reguards to the lower fin hitting the ground and the angle of...
12-24-2013, 07:58 PM
Replies: 6
Views: 1,939
Posted By barry wetherell

Well I'm another one chasing a spinner for a...

Well I'm another one chasing a spinner for a spitty, but I require a 5 5/16" one, I have been told that will be OK for a 76"Hawker Tempest by Ian Bailey, any help anywhere???
gaday PSJDBF, merry...
Forum: Glow Engines
01-17-2013, 08:01 AM
Replies: 45,846
Views: 2,551,768
Posted By barry wetherell

RE: Welcome to Club SAITO !

Tbone, if you get stuck, use the end of a drill bit, the rocker cover will hold it in place
Barry
Forum: Glow Engines
01-03-2013, 03:58 AM
Replies: 45,846
Views: 2,551,768
Posted By barry wetherell

RE: Welcome to Club SAITO !

I reversed an OS FS40 last year, as a test, I rotated the cam inside out and swapped the intake and ex manifolds, it ran better than before, I don't know how long it will last, but my idea worked.
...
Forum: Glow Engines
12-05-2012, 08:22 PM
Replies: 45,846
Views: 2,551,768
Posted By barry wetherell

RE: Welcome to Club SAITO !

Can you not achieve the throttle curve, you require using expotential????
Barry
11-11-2012, 08:20 PM
Replies: 35
Views: 6,010
Posted By barry wetherell

RE: tf dc3

OK guys, the conversion to E/P ... some say to keep the thrust angles in and others say no need for them... What is the general consensus ????:eek:
I will use the props in opp. directions
Barry
Forum: Glow Engines
10-08-2012, 04:29 PM
Replies: 45,846
Views: 2,551,768
Posted By barry wetherell

RE: Welcome to Club SAITO !

Rowdyjoe, ...I look at these factors ; 1 - how much am I going to use that engine
2 - what size model am I going to put it in
the...
Forum: Glow Engines
08-23-2012, 03:08 AM
Replies: 45,846
Views: 2,551,768
Posted By barry wetherell

RE: Welcome to Club SAITO !

Yes, well I am also having problems with this blog, I get the message saying there is a new post ,but clicking on the link, as I have been doing for 4yrs, nothing happens, [:o] I seached the forum...
Forum: Glow Engines
11-11-2011, 01:11 PM
Replies: 45,846
Views: 2,551,768
Posted By barry wetherell

RE: Welcome to Club SAITO !

Cloutmaster, have you tried Advantage Hobbies or Phil's Hobbies for your parts ??????, both of these will sell you Saito parts
Barry
08-24-2011, 10:18 PM
Replies: 708
Views: 103,566
Posted By barry wetherell

RE: SMALL DISPLACEMENT FOUR STROKE GLOW TO GAS CONVERSION

Yea , mount the sensor bracket ( I can ok, i'm not sure what you mean here
""and drill the holes, Use the same pattern as FG20 or FG30 and wai....." do you mean drill the hole for the...
08-24-2011, 09:36 PM
Replies: 708
Views: 103,566
Posted By barry wetherell

RE: SMALL DISPLACEMENT FOUR STROKE GLOW TO GAS CONVERSION

Adrian, as I have just replaced the crank bearings, I bought a new ft drive boss and taper coller, which is now not locked onto the shaft, should I run the motor first, on glow fuel before I drill a...
08-24-2011, 09:21 PM
Replies: 708
Views: 103,566
Posted By barry wetherell

RE: SMALL DISPLACEMENT FOUR STROKE GLOW TO GAS CONVERSION

Adrian very impressive, tell me where do you get those little tacho's from????
yea the price is good, let me know when you require some $$$$$'s do I just" send money" through P/Pal to your email...
08-24-2011, 08:14 PM
Replies: 708
Views: 103,566
Posted By barry wetherell

RE: SMALL DISPLACEMENT FOUR STROKE GLOW TO GAS CONVERSION

Adrian Have you worked out a cost yet????
Thanks
Barry
08-24-2011, 06:17 AM
Replies: 708
Views: 103,566
Posted By barry wetherell

RE: SMALL DISPLACEMENT FOUR STROKE GLOW TO GAS CONVERSION

Adrian, I have Recel A-01 CDI, that should be OK ?????
Barry
08-24-2011, 06:09 AM
Replies: 708
Views: 103,566
Posted By barry wetherell

RE: SMALL DISPLACEMENT FOUR STROKE GLOW TO GAS CONVERSION

Adrian, you are a blessing,:) only need 4 1/2 yards, thanks, I have accumulated all the rest except the carby and manifold for the saito 180.
PM me is you wish or I can email you at the address...
08-24-2011, 04:45 AM
Replies: 708
Views: 103,566
Posted By barry wetherell

RE: SMALL DISPLACEMENT FOUR STROKE GLOW TO GAS CONVERSION

Ï looked up Towers they have DLE 30 carby for $Aus 30.00 so if all else fails I get that one
Barry
08-24-2011, 04:36 AM
Replies: 708
Views: 103,566
Posted By barry wetherell

RE: SMALL DISPLACEMENT FOUR STROKE GLOW TO GAS CONVERSION

Yea, I tried that link, but after I bought it , no money changed hands, the man said "oh your in Australia, we don't send there" [:@], so I proceeded to the Bay and got a couple of carbs off there, 3...
Forum: Glow Engines
08-23-2011, 11:46 PM
Replies: 45,846
Views: 2,551,768
Posted By barry wetherell

RE: Welcome to Club SAITO !

NQ,... no i have never been to QLD, i day I hope perhps the wetherell was spelt differently, but don't hold me on that
there are not many of us around, my grandfather he was an only male, came from...
08-23-2011, 06:54 PM
Replies: 708
Views: 103,566
Posted By barry wetherell

RE: SMALL DISPLACEMENT FOUR STROKE GLOW TO GAS CONVERSION

ADrian, whe re do I get the zama C1qp8 from ???
Barry
08-23-2011, 04:03 PM
Replies: 708
Views: 103,566
Posted By barry wetherell

RE: SMALL DISPLACEMENT FOUR STROKE GLOW TO GAS CONVERSION

HI, guys, I need a little help here, I am trying to convert my saito 180 over to gas (petrol) can any one assist me n locateing a walbro carby for the project, in one thread it is mention a WT-456-1...
Forum: Glow Engines
08-23-2011, 07:07 AM
Replies: 45,846
Views: 2,551,768
Posted By barry wetherell

RE: Welcome to Club SAITO !

Have you checked out E/Bay???? for 45 pistons, Phils hobbies might have
Barry
Showing results 1 to 25 of 66
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.