RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: pcg33k
Showing results 1 to 25 of 328
Search took 0.50 seconds.
04-30-2010, 09:06 PM
Replies: 25
Views: 6,095
Posted By pcg33k

RE: gas bag setup

Amen to that Amax.
04-29-2010, 09:45 PM
Replies: 25
Views: 6,095
Posted By pcg33k

RE: gas bag setup

thanks for the encouragement I'll remember that next time I'm covered in gas :D
04-28-2010, 07:56 PM
Replies: 25
Views: 6,095
Posted By pcg33k

RE: gas bag setup

Thanks I'll give it another try. [:@]
04-28-2010, 06:25 PM
Replies: 25
Views: 6,095
Posted By pcg33k

RE: gas bag setup

What a freaking mess! I smell like a freaking gas station I put some fuel in the iv bag, reversed pumping the fuel in to get the air out and that didn't work so I unplugged the line from gas tank...
04-27-2010, 08:03 AM
Replies: 25
Views: 6,095
Posted By pcg33k

RE: gas bag setup

magnum57 I have the same gas tank setup so I'll try revering the pump once I've filled the bag with fuel. Do you end up burping it each time the bag is filled?
04-26-2010, 09:34 PM
Replies: 25
Views: 6,095
Posted By pcg33k

RE: gas bag setup

Thanks T29, I had my gas line connected to the top I'll break in my gas bag and move the incoming fuel line to the bottom nipple. What's the best way to burp these fuel bags? Once I break in the...
04-26-2010, 08:16 PM
Replies: 25
Views: 6,095
Posted By pcg33k

RE: gas bag setup

The carb I'm using is a 644. When I used to have a plastic fuel tank there is used to be one line that would run to the carb and then one under the carb that would run back to the tank then from the...
04-25-2010, 07:18 PM
Replies: 25
Views: 6,095
Posted By pcg33k

gas bag setup

I have just finished putting back together my AM avenger pro and have replaced my gas tank with a gas iv bag. I'm wondering why when I prime the carb no gas is being pulled from bag into carb. I...
04-11-2010, 12:44 PM
Replies: 3
Views: 573
Posted By pcg33k

RE: servo for airtronics receiver

Thanks Ron. Is there a way to know what servos will fit which receivers? Since the servo is old I think I'm just gonna buy a new one.
04-11-2010, 08:21 AM
Replies: 3
Views: 573
Posted By pcg33k

servo for airtronics receiver

Does anybody know which servo would be a good servo to use with my airtronics receiver. It would be the servo that controls the throttle. The one I have right now the plug does not fit into the...
01-30-2010, 07:05 PM
Replies: 11
Views: 1,652
Posted By pcg33k

RE: Ponds or lakes

Hey Ron,
I live 5 minutes from the pond that's off of I-55 I've run my nitro boat there once. Its a little weedy unfortunatley, I did meet a guy at a race once that was held at Naperville High...
01-26-2010, 09:04 PM
Replies: 11
Views: 1,652
Posted By pcg33k

RE: Ponds or lakes

Hey Ron,
I stopped at a race at Naperville High School I think it was Nequa (not sure if that's spelled right). They were all nitro boats racing no gas boats. I have visited that pond west of...
01-23-2010, 02:06 PM
Replies: 11
Views: 1,652
Posted By pcg33k

Ponds or lakes

Any clubs near Plainfield, IL? If so where do you guys take your boats to? I have plenty of ponds near me but are in residential and my boat is a little loud or the ponds are to small or filled...
01-23-2010, 01:28 PM
Replies: 14
Views: 1,323
Posted By pcg33k

RE: wagons

Thanks Scooter for the pics really like the idea.
01-22-2010, 09:08 PM
Replies: 14
Views: 1,323
Posted By pcg33k

RE: wagons

Could you email me some pics I'd like to make one similar to yours. Thanks
01-22-2010, 09:05 PM
Replies: 38
Views: 8,363
Posted By pcg33k

RE: Aeromarine Avenger Pro

Does anybody know where to get the shims for the rudder?
01-22-2010, 06:56 PM
Replies: 14
Views: 1,323
Posted By pcg33k

RE: wagons

Now thats what I'm talking about scooter. Great idea. It carries all your stuff plus its a table. Excellent idea you should sell them. :)
01-21-2010, 11:00 PM
Replies: 14
Views: 1,323
Posted By pcg33k

wagons

What does everyone use to bring their boat to the pond? I carry my boat from the car to the pond making numerous trips to get gas can, toolbox, drinks. I'm thinking of making a wagon that will hold...
12-23-2009, 07:31 PM
Replies: 1
Views: 469
Posted By pcg33k

newbie to cars

I'm new to cars but not rc. I've had several nitro boats and currently own a gas rc boat. I'm thinking of buying this one http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXRSJ0**&P=7 what do you...
10-14-2009, 06:41 PM
Replies: 5
Views: 808
Posted By pcg33k

RE: 2 zen's in a aeromarine avenger

Got the pm's Paul thanks. Very cool videos
10-13-2009, 07:11 PM
Replies: 5
Views: 808
Posted By pcg33k

RE: 2 zen's in a aeromarine avenger

Hey Paul do you know what the link is?
10-11-2009, 09:49 PM
Replies: 5
Views: 808
Posted By pcg33k

2 zen's in a aeromarine avenger

Has anybody tried stuffing 2 zen 260's in a aeromarine avenger? Just curious was searching on youtube and just wondered if anybody attempted it.
10-11-2009, 08:30 PM
Replies: 4
Views: 543
Posted By pcg33k

RE: winter storage for engines

Ok thanks for the tips.
10-11-2009, 08:17 PM
Replies: 4
Views: 543
Posted By pcg33k

winter storage for engines

Well its getting to that time of year here in Illinois so it looks like I'm gonna have to put the boat away for the season. What do I need to do with the engine is there anything special other than...
10-05-2009, 04:37 PM
Replies: 12
Views: 1,089
Posted By pcg33k

RE: ram air for am avenger pro

Interesting idea have to keep that in mind.
Showing results 1 to 25 of 328
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.