Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: Jay-Em
Showing results 1 to 25 of 103
Search took 0.16 seconds.
Forum: RC Tanks
09-15-2020, 05:05 AM
Replies: 11
Views: 457
Posted By Jay-Em

Edit: bearings needed are these ďMST120019...

Edit: bearings needed are these ďMST120019 Bearing 8x12Ē or any other 8x12, NOT 8x14, like I erroneously mentioned in the above post. Sorry.

For the tanks I use in really dirty, sandy terrain, I...
Forum: RC Tanks
09-15-2020, 04:52 AM
Replies: 175
Views: 8,511
Posted By Jay-Em

n‚h.. Die Probleme sind die Folge von was Ich...

n‚h.. Die Probleme sind die Folge von was Ich nenne ď ‹berautomatisieringĒ . Forum Server spam monitoring tool ( Barracuda oder so etwas) sieht da Ďne IP-adresse das von irgendwo anders kommt als er...
Forum: RC Tanks
09-15-2020, 04:33 AM
Replies: 17
Views: 818
Posted By Jay-Em

One little tip if You use Taigen or Torro ( never...

One little tip if You use Taigen or Torro ( never understood the difference) electronics : Be very careful when using LiPo. I blew 2 controllers before Taigen/torro officially warned against using...
Forum: RC Tanks
09-15-2020, 04:05 AM
Replies: 27
Views: 895
Posted By Jay-Em

To a certain extent. You see the little dogbones...

To a certain extent. You see the little dogbones to the right? They limit steering throw quite significantly and take a bit of adjusting and tinkering. I usually have to take about 0.5mm of each end...
Forum: RC Tanks
09-13-2020, 06:55 AM
Replies: 13
Views: 525
Posted By Jay-Em

Usually the higher gear ratio gearboxes come with...

Usually the higher gear ratio gearboxes come with the correct motors already attached.
Forum: RC Tanks
09-13-2020, 06:08 AM
Replies: 15
Views: 1,128
Posted By Jay-Em

Well.. at least it has a Deans for the...

Well.. at least it has a Deans for the battery....:p
Forum: RC Tanks
09-13-2020, 05:56 AM
Replies: 1
Views: 239
Posted By Jay-Em

It sounds like the springs that keep the clutches...

It sounds like the springs that keep the clutches disengaged, are either broken, or just worn-out. Disassembling them is the only way to be certain, I’m afraid. Be aware of parts that go ‘sproing’...
Forum: RC Tanks
09-13-2020, 05:47 AM
Replies: 11
Views: 457
Posted By Jay-Em

yeahh.. thatís what they do best... grenade in a...

yeahh.. thatís what they do best... grenade in a very short time...

However, the latest iterations have actual steel gears on board. And a SMOKER ( i put this in capitals, because.. man.. it...
Forum: RC Tanks
09-13-2020, 05:32 AM
Replies: 175
Views: 8,511
Posted By Jay-Em

If the gears are anything like those that Tamiya...

If the gears are anything like those that Tamiya puts in its cars, I very much doubt that steel gears are necessary. They’re not Heng Long plastic, so to say. Added bonus of plastic gears is the...
Forum: RC Tanks
09-13-2020, 05:12 AM
Replies: 13
Views: 525
Posted By Jay-Em

Time for some 390ís, me thinks. They will most...

Time for some 390ís, me thinks. They will most certainly do the trick. You could ask Eric at IMEX too. Heíll probably have a solution already.
In the worst case Youíll have to buy two whole new...
Forum: RC Tanks
09-13-2020, 05:05 AM
Replies: 27
Views: 895
Posted By Jay-Em

Check the usual chinese sites for ‘wpl 1/16’ and...

Check the usual chinese sites for ‘wpl 1/16’ and you’ll find that they offer metal gear sets for the WPL’s. Try banggood, or tomtop or aliexpress. Sets are about $6 to $8 ( some googling would have...
Forum: RC Tanks
04-18-2020, 12:34 AM
Replies: 4
Views: 363
Posted By Jay-Em

Dangit!! That’s really exellent!

Dangit!! That’s really exellent!
04-18-2020, 12:28 AM
Replies: 6
Views: 1,557
Posted By Jay-Em

Trx4. If only because Traxxas uses better...

Trx4.

If only because Traxxas uses better plastics than Axial.
04-18-2020, 12:17 AM
Replies: 5
Views: 1,493
Posted By Jay-Em

Yeah, itís just what sensorless brushless motors...

Yeah, itís just what sensorless brushless motors do when overgeared.
Those WL toy things are pretty fast, but the price You pay is gearing thatís actually a bit too high.

Sensored brushless motor...
Forum: RC Tanks
03-10-2020, 03:11 AM
Replies: 69
Views: 2,864
Posted By Jay-Em

Oooff.. My word. I guess we , in Northern Europe,...

Oooff.. My word. I guess we , in Northern Europe, are the lucky ones with DPD, DHL, PostNL and such. Then again, Our relative distances are shorter too, infrastructure is tighter, and most goes by...
Forum: RC Tanks
09-01-2018, 03:09 AM
Replies: 8
Views: 1,474
Posted By Jay-Em

Width needed is about 12.5 cm. Height is the same...

Width needed is about 12.5 cm. Height is the same as the low gearboxes in any Heng Long tank. A bit lower, even.
Biggest concern will be the length of one of the gearboxes. It interfered with the...
Forum: RC Tanks
08-23-2018, 01:28 PM
Replies: 49
Views: 9,686
Posted By Jay-Em

All in all, I am afraid that the T-90 is the last...

All in all, I am afraid that the T-90 is the last new release for the coming years. Shame. All that money and time HL invested, and wasted (imho) on metal big-scale monsters.

Maybe Tamiya has...
Forum: RC Tanks
08-23-2018, 12:42 PM
Replies: 16
Views: 1,313
Posted By Jay-Em

Hah! Then -when using the DKLMRC gearboxes- The...

Hah! Then -when using the DKLMRC gearboxes- The Sky Is The Limit. 2x180 amp will comfortably pull even fast 12-turn 550’s. Then You’ll have a tracked truck that potentially could hit 25 to 30km/h.....
Forum: RC Tanks
08-23-2018, 12:23 PM
Replies: 16
Views: 1,313
Posted By Jay-Em

Planetary is even better. Bit more complex to...

Planetary is even better. Bit more complex to realize, though. In that case, the bigger length of 550’s is no problem whatsoever. For cheap 55- to 80 turn 540 motors, take a look at the Absima...
Forum: RC Tanks
08-23-2018, 11:54 AM
Replies: 16
Views: 1,313
Posted By Jay-Em

My Leo has about 12,8 to 13cm of space in the...

My Leo has about 12,8 to 13cm of space in the hull and the DKLM gearboxes fit fine, with a little wiggle-room left.. So, Your hull/chassis is wide enough for the big ones. If You can afford the $90.-...
Forum: RC Tanks
08-21-2018, 03:21 AM
Replies: 16
Views: 1,313
Posted By Jay-Em

I fully agree with Tankme here. The DKLMRC 550...

I fully agree with Tankme here.
The DKLMRC 550 gearboxes are as sturdy as they come, and fit any 540/550 motor.
The only problem could be the width available in the chassis tub. The 550 motors are...
Forum: RC Tanks
08-10-2018, 11:18 AM
Replies: 9
Views: 1,793
Posted By Jay-Em

Ah, yes. Changing the sprocket is also an option....

Ah, yes. Changing the sprocket is also an option. Something that I noticed with -indeed- the T-90. It was So. Slow. Bigger sprocket, more teeth, bigger circumference = higher speed. ‘Instant...
Forum: RC Tanks
08-10-2018, 06:26 AM
Replies: 9
Views: 1,793
Posted By Jay-Em

the stock 390 motors taigen fits are 18000rpm...

the stock 390 motors taigen fits are 18000rpm long-cans. I actually meant these motors:Taigen 25000 rpm 390...
Forum: RC Tanks
08-09-2018, 07:10 AM
Replies: 9
Views: 1,793
Posted By Jay-Em

Maybe a bit redundant, but did You try the...

Maybe a bit redundant, but did You try the 390/480 (25000rpm) Taigen motors in the steel 1:3 gearboxes in the M26?

I tested that combi in my Leo before I fit the big 550 gearboxes, and it was...
Forum: RC Tanks
08-08-2018, 06:27 AM
Replies: 8
Views: 1,474
Posted By Jay-Em

Forgot to add pics of the gearboxes inside the...

Forgot to add pics of the gearboxes inside the tub. It’s a tight fit when one wants to keep the battery-box intact, but nothing that a slight nip&cut from a Dremel cannot fix.
...
Showing results 1 to 25 of 103
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright © 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.