Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: JimO
Showing results 1 to 25 of 500
Search took 0.96 seconds.
03-27-2020, 02:28 PM
Replies: 26
Views: 20,116
Posted By JimO

Plane has both flaps and ailerons. Flaps have a...

Plane has both flaps and ailerons. Flaps have a single servo mounted mid wing. I will check but should have the plans.
Forum: Kit Building
06-18-2019, 10:41 AM
Replies: 3,805
Views: 209,366
Posted By JimO

This was a brand new switch, three wire universal...

This was a brand new switch, three wire universal with charge jack. No black wire on this switch. Usually this is from silver plated wire that had not cured well before extruding the covering. Took...
Forum: Kit Building
06-18-2019, 04:59 AM
Replies: 3,805
Views: 209,366
Posted By JimO

Lost my Sportsman

We check the controls, fine tune the engine, range check the radio, however, ever check the RX on off switch to make sure it "Clicks" both on and off. Had flown this plane a few times and guess was...
Forum: Kit Building
04-13-2019, 02:37 AM
Replies: 1,215
Views: 191,817
Posted By JimO

Bought a few in the past from them. Miss the...

Bought a few in the past from them. Miss the Unionville kits they used to sell. Another great kit company gone!
Forum: Glow Engines
11-29-2018, 03:45 PM
Replies: 48,971
Views: 2,829,338
Posted By JimO

I would you with the 14. The would not have...

I would you with the 14. The would not have enough power to really pull the Kaos. Bigger is better and you can always throttle back.
Forum: Kit Building
04-29-2018, 06:28 AM
Replies: 1,215
Views: 191,817
Posted By JimO

Building Top Notch Bush Hawk

Kit is complete, just like years past. There is something about taking a box of wood and make it come to life.
Forum: Kit Building
12-25-2014, 04:47 AM
Replies: 1,215
Views: 191,817
Posted By JimO

Just got a BushHawk from Topnotch Kits. A true...

Just got a BushHawk from Topnotch Kits. A true build it kit, plus they have others. "Made in America"
Jim
Forum: Kit Building
08-19-2014, 02:06 AM
Replies: 11
Views: 1,476
Posted By JimO

I will check my plans box tonight for both. If i...

I will check my plans box tonight for both. If i still have will cost you postage only.

Jim O
Tallahassee, FL
08-10-2013, 08:11 AM
Replies: 1,601
Views: 45,363
Posted By JimO

When will member block update? I am Platinum...

When will member block update? I am Platinum member and it is shows me as Basic.
Forum: ARF or RTF
08-10-2013, 07:58 AM
Replies: 11
Views: 3,104
Posted By JimO

FMS makes a B-25 Foam Electric. Retracts, Flaps...

FMS makes a B-25 Foam Electric. Retracts, Flaps LED lights. You can see it at www.diamondhobby.com (http://www.diamondhobby.com) I will have a video posted early next week

Jim
Forum: Beginners
07-04-2013, 07:53 AM
Replies: 5
Views: 492
Posted By JimO

RE: Help finding airplane scale

About an 8th scale if you do the math.
07-04-2013, 07:43 AM
Replies: 4
Views: 673
Posted By JimO

RE: A great place to buy a plane

Have a look at Diamond Hobby. www.diamondhobby.com They are listed as the U.S. Distributor of FMS products and carry the entire line.
06-28-2012, 12:32 PM
Replies: 1,127
Views: 243,818
Posted By JimO

RE: OV-10 Bronco 81

Oh I will for sure. Heat of summer has hit, so a lot of building is done in the AC.
06-28-2012, 12:14 PM
Replies: 1,127
Views: 243,818
Posted By JimO

RE: OV-10 Bronco 81

After two moves here in Tallahassee and a lot of packing and unpacking, finally back on the Bronco. First time out on her feet. Have to finish sanding and and final prep for covering.

Saito...
Forum: Kit Building
04-08-2012, 05:04 AM
Replies: 10
Views: 867
Posted By JimO

RE: looking for the right retracts for TF p40E kit

After having even Spring Air fail, going to electric for OV-10. To many connections for possible air leaks, plus a lot more scale like in operation.
Forum: Kit Building
04-07-2012, 05:20 PM
Replies: 10
Views: 867
Posted By JimO

RE: looking for the right retracts for TF p40E kit

Have a look at wingspanretracts.com.

Saw them at the big swap meet in Perry GA and they are nice.

Ordered a set for 81 inch Bronco
Forum: Kit Building
03-07-2012, 01:03 PM
Replies: 11
Views: 1,053
Posted By JimO

Good matching paint for Ultrakote

Building a 100 inch Air Tractor 502 short kit from Hollis Calvert and need to find a good matching paint for Ultrakote Cub Yellow. Any suggestions or direction appreciated.
Forum: Kit Building
04-15-2011, 04:10 AM
Replies: 151
Views: 28,644
Posted By JimO

RE: Bud Nosen 40 Citabria Build

I have a Mosquito bite Tri pacer that I had Grumpy Monkey designs in Hillsbourgh NJ do the graphics for. The owner and designer is a fellow RC 'er and former club member when I lived in NJ. Send him...
Forum: Kit Building
04-13-2011, 11:59 AM
Replies: 151
Views: 28,644
Posted By JimO

RE: Bud Nosen 40 Citabria Build

Are you doing the same scheme as the green only in Orange and white?
04-05-2011, 09:24 AM
Replies: 4
Views: 787
Posted By JimO

RE: OS FS200 remote exhaust

OS makes Flexible exhaust pipes in differnet lenghts that will fit. Graves RC have them listed.

JimO
04-05-2011, 09:01 AM
Replies: 7
Views: 803
Posted By JimO

RE: hardware supplier

I have been using JR Hobby Hardware out of NJ www.jrhobbyhardware.com Love their Aluminum Hub wheels

JimO
01-27-2011, 01:49 PM
Replies: 2
Views: 901
Posted By JimO

RE: Noorduyn Norseman Giant plans

What wing span?. Unionville Hobbies out of Canada has an 85.5 inch kit.

JimO
01-26-2011, 05:17 AM
Replies: 9
Views: 862
Posted By JimO

RE: Mosquitobite Planes

I got an email end of the year about the TRI-Pacer and how they are coming back out with it. Andy's death had areal effect on the company and I think they are just slow in recovering.


JimO
Forum: Kit Building
01-01-2011, 03:42 PM
Replies: 151
Views: 28,644
Posted By JimO

RE: Bud Nosen 40 Citabria Build

Never really weighed it, but would guess equal to. Lot depends on how you apply the water based poly. The sample I made up to do a show and tell at our club meeting this month is equal in weight to...
Forum: Kit Building
01-01-2011, 10:10 AM
Replies: 151
Views: 28,644
Posted By JimO

RE: Bud Nosen 40 Citabria Build

The fabric is 100 % polyester dress liner and you can buy it anywhere fabric is sold. Also very cheap, I did a 4PI Skyraider for about 6 dollars. you can shrink the liner with a standard hobby heat...
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.