RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: luckymacy
Showing results 1 to 25 of 498
Search took 0.83 seconds.
02-15-2020, 03:13 AM
Replies: 235
Views: 28,884
Posted By luckymacy

good to know. I had doubts the Kavan had enough...

good to know. I had doubts the Kavan had enough muscle for a 200.
02-13-2020, 05:56 PM
Replies: 235
Views: 28,884
Posted By luckymacy

Hey guys, Hobbyking and Align are out of stock of...

Hey guys, Hobbyking and Align are out of stock of their gear reduction starters. Just curious what folks here are using on their 185 and 200 engines for starters.
Forum: RC Jets
01-07-2020, 03:38 AM
Replies: 187
Views: 53,375
Posted By luckymacy

Thank you.

Thank you.
Forum: RC Jets
01-05-2020, 02:23 AM
Replies: 187
Views: 53,375
Posted By luckymacy

compared to what Iím used to, 15% seems like a...

compared to what Iím used to, 15% seems like a lot of elevator mix. Still recommend that amount for initial set up?

is the recommended Elevator 2.5 cm up and 2 cm down enough elevator throw for...
08-26-2019, 05:32 PM
Replies: 1,931
Views: 476,501
Posted By luckymacy

Mezon 130 and throttle curves

other than setting the pole to 10 and the pulse frequency to 8, what other settings are folks using? Curious about brake settings, acceleration, etc. this is for a biplane if that makes any...
Forum: Marketplace
08-10-2019, 10:50 PM
Replies: 1
Views: 548
Posted By luckymacy

PM sent.

PM sent.
03-31-2019, 09:39 AM
Replies: 56
Views: 8,697
Posted By luckymacy

I know this is ancient old but it is also exactly...

I know this is ancient old but it is also exactly what I've had in mind as well. How large are the openings and how far away from the back did you keep from cutting into so there was clearance...
02-16-2019, 07:26 PM
Replies: 676
Views: 132,975
Posted By luckymacy

Can you elaborate on your tail wheel pull pull...

Can you elaborate on your tail wheel pull pull setup? Any pictures?
02-16-2019, 11:54 AM
Replies: 0
Views: 584
Posted By luckymacy

Sebart contra drive?

SEBCDM-01 SebArt Contra Drive System w/Hacker C50-12XL Competition Motor, Gearbox, Soft Mount, props and spinner - SebArt Airplanes (http://www.jramericas.com/235342/SEBCDM01/)

If anyone has first...
02-08-2019, 01:25 PM
Replies: 14
Views: 6,394
Posted By luckymacy

Bo, Can you update the link so it works again? ...

Bo, Can you update the link so it works again?

thx,
lucky
11-12-2018, 04:07 AM
Replies: 87
Views: 17,494
Posted By luckymacy

Excellent job. Where is everyone getting those...

Excellent job. Where is everyone getting those blue foam plane stands? The couple times I've run across them they are always sold out. One thing to consider doing to help the gear box survive, as...
11-02-2018, 04:15 AM
Replies: 41
Views: 7,114
Posted By luckymacy

why not just go contra instead of all the install...

why not just go contra instead of all the install hassle without the contra drive benefits?
10-31-2018, 02:21 PM
Replies: 41
Views: 7,114
Posted By luckymacy

LOL, it's already here - bell bottoms and contra...

LOL, it's already here - bell bottoms and contra drive biplanes!

Anybody owned a contra drive biplane and decided it wasn't that great after all and ditched it? I see a lot of bipes like the...
10-21-2018, 02:24 AM
Replies: 3
Views: 1,002
Posted By luckymacy

Why would one pick this over the Etude and is...

Why would one pick this over the Etude and is there a contra drive version in the works? That's what the market is missing. A composite fuse, sub $2K, non T-Can contra drive setup that is lightweight...
10-13-2018, 02:36 PM
Replies: 25
Views: 5,008
Posted By luckymacy

i'm not really familiar with the Adverrun with up...

i'm not really familiar with the Adverrun with up close and personal pictures of the install nor have I run across anyone flying with that yet. How does it compare with BJ's with respect to...
10-12-2018, 02:23 AM
Replies: 25
Views: 5,008
Posted By luckymacy

There's a thread on his X drive going back to...

There's a thread on his X drive going back to 2016. No one in the US has one installed and flying yet though? No head to head specs or subjective impressions by anyone between this and Brenner's...
10-01-2018, 04:22 AM
Replies: 151
Views: 36,726
Posted By luckymacy

Purchase carbon source?

I like what you did and I too fly off of a field that is notoriously swampy soft and reminds me of walking on a wet sponge. It causes a lot of issues or just makes where you canít fly for a month or...
Forum: Marketplace
06-17-2018, 11:51 AM
Replies: 14
Views: 841
Posted By luckymacy

Channels needed

https://cimg0.ibsrv.net/gimg/www.rcuniverse.com-vbulletin/2000x1504/7112a904_97b7_44d5_a981_065792e319fb_e61df012977f98d47db36b5263528964bbb8ff4f.jpeg
Forum: Marketplace
06-17-2018, 11:06 AM
Replies: 14
Views: 841
Posted By luckymacy

Additional pictures

https://cimg5.ibsrv.net/gimg/www.rcuniverse.com-vbulletin/2000x1504/3bf96e3b_5001_424a_b540_b227028749bc_5af2aa0788986af65262b37c610c12cc338699ab.jpeg...
Forum: Marketplace
06-17-2018, 06:40 AM
Replies: 14
Views: 841
Posted By luckymacy

Bomb drop mechanism

https://youtu.be/w2TkqyXgOuk
Forum: Marketplace
06-17-2018, 06:38 AM
Replies: 14
Views: 841
Posted By luckymacy

Flaps

https://youtu.be/VbeMo5NHZTk
Forum: Marketplace
06-17-2018, 06:36 AM
Replies: 14
Views: 841
Posted By luckymacy

Retracts

https://youtu.be/7O80I2QqY4A
Forum: Marketplace
06-17-2018, 06:29 AM
Replies: 14
Views: 841
Posted By luckymacy

Like I said, this combo is a steal. What I...

Like I said, this combo is a steal. What I failed to mention up front though is that I use Jeti equipment and the receiver is not included however thereís nothing specific to Jeti that will cause an...
Forum: Marketplace
06-17-2018, 06:25 AM
Replies: 14
Views: 841
Posted By luckymacy

Additional pictures and engine run this morning

https://cimg9.ibsrv.net/gimg/www.rcuniverse.com-vbulletin/2000x1504/1cdf8551_0a35_471c_a9c3_7acecde783fd_c368854fd7fda957454b3b1c8b19224cd770a612.jpeg...
Forum: Marketplace
06-13-2018, 05:30 PM
Replies: 14
Views: 841
Posted By luckymacy

Sorry but donít want to ship.

Sorry but donít want to ship.
Showing results 1 to 25 of 498
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright © 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.