RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: Bax
Showing results 1 to 5 of 5
Search took 0.03 seconds.
12-29-2014, 09:26 AM
Replies: 20
Views: 12,567
Posted By Bax

That brass ring was a spacer so that the...

That brass ring was a spacer so that the crankshaft would be properly-aligned inside the crankcase. You cannot run without it. Unfortunately, that would have been on older engines that have not had...
11-14-2011, 09:35 AM
Replies: 20
Views: 12,567
Posted By Bax

RE: Super Tigre (made in Italy) Parts

Use a paper gasket. You can make one out of card stock, bakers' parchment paper, regular notebook paper, and so on. It's not critical, but you do need one to at least keep oil seepage down.
06-22-2011, 06:46 AM
Replies: 20
Views: 12,567
Posted By Bax

RE: Super Tigre (made in Italy) Parts

The connecting rod, piston, and crankshaft are for the G-90 only. The piston ring and liner will work for the S-90, and later engines. If you look up the parts list for the G-90, the parts that...
06-21-2011, 06:09 AM
Replies: 20
Views: 12,567
Posted By Bax

RE: Super Tigre (made in Italy) Parts

Pistons and rings for the S-series engines are the same ones used in the current G-series engines. Several other parts also cross between engines. The .61's have more parts in common than the...
06-20-2011, 06:08 AM
Replies: 20
Views: 12,567
Posted By Bax

RE: Super Tigre (made in Italy) Parts

Any parts listed at Tower are for the current-production engines, however, they will fit quite a number of older engines of similar design. Which engines, specifically do you have? We need to know...
Showing results 1 to 5 of 5


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.