RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: Tidnab
Showing results 1 to 25 of 500
Search took 0.82 seconds.
05-23-2020, 04:32 AM
Replies: 2
Views: 443
Posted By Tidnab

Your problem may be that it is a clone and not an...

Your problem may be that it is a clone and not an original Honda GX35. The Honda 4 stroke trimmer engines can be run in any position while running or being stored and won't leak.I was told this was...
05-22-2020, 10:32 AM
Replies: 1
Views: 195
Posted By Tidnab

Your water pump needs pulse from the engine to...

Your water pump needs pulse from the engine to operate.That line either goes to a pulse fitting on your carb block or a fitting placed on you engines crankcase.You can buy carb blocks with the...
05-04-2020, 04:46 PM
Replies: 1
Views: 134
Posted By Tidnab

I don't like a muffler hanging off the end of a...

I don't like a muffler hanging off the end of a tuned pipe so I use pipes with internal stingers in them. If one doesn't already have it I use a piece of brass tube that fits snug into the stinger...
05-02-2020, 03:11 PM
Replies: 5
Views: 208
Posted By Tidnab

I would suggest if you want any speed out of it...

I would suggest if you want any speed out of it to replace that straight shaft with a curved one which would be subsurface or even better yet a surface drive.Straight shafts angled down at mostly on...
04-30-2020, 05:59 PM
Replies: 5
Views: 208
Posted By Tidnab

Xjsport95 Boat and Engine

Ok, it's air cooled.It may be 25cc or 30cc depending if it has a bridge in the exhaust opening.I think those old JDs were like the Homelites.Could use some more trimming on the plastic shroud.Looks...
04-30-2020, 02:49 PM
Replies: 5
Views: 208
Posted By Tidnab

It's a heavy hull even without the gas engine and...

It's a heavy hull even without the gas engine and would take a large electric motor to push it. The motor would cost more than the old hull is worth. Why not fix the motor that's in it and have fun...
04-12-2020, 02:12 PM
Replies: 2
Views: 268
Posted By Tidnab

Can't seem to find any info on a Sarga engine. Do...

Can't seem to find any info on a Sarga engine. Do you have a link to them ?
04-12-2020, 08:38 AM
Replies: 10
Views: 422
Posted By Tidnab

There's videos online showing a boat like yours...

There's videos online showing a boat like yours in the water. There is probably some threads on r/c boat forums for upgrades,like modern electronics,radio and brushless motors and batteries.
04-10-2020, 05:35 AM
Replies: 10
Views: 422
Posted By Tidnab

Here's pics of your KD Perkasa MTB boat. ...

Here's pics of your KD Perkasa MTB boat.
https://cimg0.ibsrv.net/gimg/www.rcuniverse.com-vbulletin/386x514/img_3726_7b66e3bd1184f79ebe6933601299565ba65914ea.jpg...
04-09-2020, 01:08 PM
Replies: 10
Views: 422
Posted By Tidnab

PM me the link to your boats pics on Facebook. I...

PM me the link to your boats pics on Facebook. I probably could save them from there and then repost them to here.
04-08-2020, 12:24 PM
Replies: 10
Views: 422
Posted By Tidnab

chrish85,sent you a PM.

chrish85,sent you a PM.
04-08-2020, 03:22 AM
Replies: 4
Views: 761
Posted By Tidnab

There's a deeper V hull that many have made and...

There's a deeper V hull that many have made and can be made smaller if needed.You can adjust the side depth on all frames if needed. I would also add a keel and use stringers to add gluing...
03-29-2020, 03:50 PM
Replies: 4
Views: 548
Posted By Tidnab

Expresscraft has some big v hulls Welcome to...

Expresscraft has some big v hulls Welcome to Expresscraft Boats (http://www.expresscraft.com/)
03-28-2020, 06:18 PM
Replies: 32
Views: 10,875
Posted By Tidnab

I used to have the yellow Shockwave and bought it...

I used to have the yellow Shockwave and bought it new from Horizon Hobby back in 2005 and it had a Zen 26 cc in it.The earlier versions had the Zen 23cc.There should be a tag on the motor saying what...
Forum: RC Airboats
03-05-2020, 05:01 PM
Replies: 3
Views: 663
Posted By Tidnab

What about the full body airplane pilots.They...

What about the full body airplane pilots.They should come in various scale.
02-27-2020, 07:50 PM
Replies: 0
Views: 436
Posted By Tidnab

Miss US U2 Picklefork Hydroplane

Has anyone built this 1/8 scale thunderboat from plans ? It calls for a .65 nitro engine,but could a Zenoah 26cc be used or even the Zenoah 20cc with a few adjustments,like engine rails, engine...
02-17-2020, 11:28 AM
Replies: 3
Views: 755
Posted By Tidnab

What boat manufacturer ? Pics of it would...

What boat manufacturer ? Pics of it would help,from top, bottom, sides and transom.
01-23-2020, 04:37 PM
Replies: 4
Views: 761
Posted By Tidnab

If you want to try a wood hull next here's the...

If you want to try a wood hull next here's the plans for the Wasabi 900 at 36' and it's bigger version the Wasabi 1300,which both can be up or downsized to what you want.Offshore Electrics should...
Forum: Marketplace
01-02-2020, 05:33 PM
Replies: 0
Views: 208
Posted By Tidnab

Radio Shack ATV

Radio Shack Road Rustler ATV 60-4235 in good condition. Has soft rubber tires and comes with instructions,charger ,transmitter and 9.6 volt battery.Runs forward and backward,but only turns once in a...
12-31-2019, 03:53 PM
Replies: 5
Views: 1,281
Posted By Tidnab

Here they are for the Thriftway in PDF. If you...

Here they are for the Thriftway in PDF. If you need others let me know.You can put these on a disc or just print them out and take it to a Staples store near you and tell them what percent you want...
12-30-2019, 07:51 PM
Replies: 5
Views: 1,281
Posted By Tidnab

Rum Runner Racing has the plans for the 1958 Miss...

Rum Runner Racing has the plans for the 1958 Miss Thriftway Too that could be sized up. Build Contest - Rum Runner Racing (http://www.rumrunnerracing.com/plans.html)
Forum: RC Combat
12-17-2019, 04:55 AM
Replies: 4
Views: 932
Posted By Tidnab

Some used to make combat airplanes from...

Some used to make combat airplanes from coroplast.Here's free plans Free Plans (http://www.spadtothebone.net/freeplans.htm) and here their forum http://spadworld.net/forum/ These used to be...
11-05-2019, 04:08 AM
Replies: 11
Views: 1,451
Posted By Tidnab

I sent you a PM.

I sent you a PM.
10-25-2019, 07:30 AM
Replies: 5
Views: 1,281
Posted By Tidnab

If you're willing to build from a kit,ML...

If you're willing to build from a kit,ML Boatworks has a few in 1/6 scale,but you would have to know the plan number from Newton plans or just buy plans from Newton and get them scaled to your size....
10-24-2019, 02:59 AM
Replies: 2
Views: 1,216
Posted By Tidnab

Thanks Ron,that smaller Amps cover might work on...

Thanks Ron,that smaller Amps cover might work on the 7.5. I'll have to try to contact DPI on Facebook.That's where I got a part for a DPI crackerbox.
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.