Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: A. J. Clark
Showing results 1 to 25 of 479
Search took 0.71 seconds.
10-21-2020, 05:12 AM
Replies: 5
Views: 142
Posted By A. J. Clark

Looks like in the video you have a brush motor. ...

Looks like in the video you have a brush motor. If you have voltmeter you can check the voltage going to the motor from the esc.
Forum: The Clubhouse
10-12-2020, 07:50 AM
Replies: 7
Views: 656
Posted By A. J. Clark

That is very cool. Your friend is very talented. ...

That is very cool. Your friend is very talented.

Reminds me when I was a kid . Where I lived there was two old Ford trucks (maybe model a or t). One had a flat bed on it with one of those small...
09-28-2020, 01:11 PM
Replies: 17
Views: 979
Posted By A. J. Clark

Another way to go at it is adjust both low and...

Another way to go at it is adjust both low and high setting just a little rich. Then make 4- 5 flights at full throttle or close to full throttle. This will help break the engine in and should help...
09-27-2020, 09:47 AM
Replies: 17
Views: 979
Posted By A. J. Clark

A new engine will run a little leaner each flight...

A new engine will run a little leaner each flight until it broken in. The high end needs to be checked each flight for the first few flights. Probably first ten flights.

I like to set the idle a...
09-27-2020, 04:32 AM
Replies: 17
Views: 979
Posted By A. J. Clark

Try a little richer fuel setting. Especially the...

Try a little richer fuel setting. Especially the idle.
09-23-2020, 04:16 PM
Replies: 4
Views: 485
Posted By A. J. Clark

Another thought is if the control rod to the...

Another thought is if the control rod to the rudder is to far out on the servo horn can cause problems.
09-23-2020, 04:06 PM
Replies: 1
Views: 297
Posted By A. J. Clark

Really good looking plane and nice flight. Your...

Really good looking plane and nice flight. Your friend should be proud of it.
09-23-2020, 10:13 AM
Replies: 4
Views: 485
Posted By A. J. Clark

Is your motor running smoothly? Bearings all in...

Is your motor running smoothly? Bearings all in good condition? One way ok? Clutch holding good? All of these cause a kick on the tail.
09-19-2020, 06:18 PM
Replies: 1
Views: 686
Posted By A. J. Clark

https://cimg3.ibsrv.net/gimg/www.rcuniverse.com-vb...

https://cimg3.ibsrv.net/gimg/www.rcuniverse.com-vbulletin/2000x1124/20200802_180809_87d5c99decb085c928222c7c8fc28ce17c1453d0.jpg
09-10-2020, 04:41 AM
Replies: 21
Views: 773
Posted By A. J. Clark

If your useing 2 separate systems and one ...

If your useing 2 separate systems and one battery dies or rx goes bad the servos will stop where there at . Won't be able to go to fail safe.
09-04-2020, 02:14 PM
Replies: 137
Views: 24,128
Posted By A. J. Clark

Neat flight I liked it. Looks like a great...

Neat flight I liked it. Looks like a great flying plane . Don't let that beauty set in the corner anymore.
Forum: The Clubhouse
09-01-2020, 05:24 PM
Replies: 8
Views: 557
Posted By A. J. Clark

They are updating the photo gallery....

They are updating the photo gallery. https://www.rcuniverse.com/forum/forum-questions-problems-239/11675152-my-gallery.html
08-29-2020, 08:24 AM
Replies: 1
Views: 247
Posted By A. J. Clark

Your plane may not be balanced in the right...

Your plane may not be balanced in the right location. Have you ckecked the balance location. If possible move the battery a little and make test flight. May have to add weight.
08-02-2020, 02:30 PM
Replies: 3
Views: 448
Posted By A. J. Clark

What's your charge rate? Is it proportional to...

What's your charge rate? Is it proportional to your other batteries? If you bump up the charge current the voltage will probably go up in the end too.
Forum: 3D Flying!
08-02-2020, 08:10 AM
Replies: 14
Views: 624
Posted By A. J. Clark

Sometimes to go inverted I make a turn . When...

Sometimes to go inverted I make a turn . When the wing is at a high bank put in some down elevator and roll the wing on over and you will be inverted.
Replies: 3
Views: 308
Posted By A. J. Clark

You can use a servo tester to rotate the servo...

You can use a servo tester to rotate the servo but it doesn't work exactly like your thinking. You need a power supply. 5v would do it for most servos. Plus you need a signal that can be pulse width...
07-16-2020, 07:29 PM
Replies: 6
Views: 702
Posted By A. J. Clark

Bad connection on the balance plug/cable.

Bad connection on the balance plug/cable.
07-06-2020, 07:13 AM
Replies: 4
Views: 609
Posted By A. J. Clark

Have you checked the monitor screen to see if the...

Have you checked the monitor screen to see if the rudder and gyro channel are working. Is everything pluged into the right port.
07-05-2020, 09:12 AM
Replies: 4
Views: 609
Posted By A. J. Clark

Have you set the gain for the rudder. I believe...

Have you set the gain for the rudder. I believe if the gain is to low you will have the problem you describe .
Forum: Gas Engines
06-20-2020, 12:28 PM
Replies: 6
Views: 509
Posted By A. J. Clark

Maybe internal carb problem causing the unwanted...

Maybe internal carb problem causing the unwanted behavior?
05-28-2020, 03:51 PM
Replies: 10
Views: 838
Posted By A. J. Clark

If you turn power lead around and still don't get...

If you turn power lead around and still don't get any lights to come on then take your ESV meter and plug it into another receiver slot to see if there is any voltage on the pins.
05-28-2020, 05:55 AM
Replies: 10
Views: 838
Posted By A. J. Clark

I don't see in the diagram were it shows polarity...

I don't see in the diagram were it shows polarity for the power wires so I would try changing the orientation of the power wires.
05-28-2020, 04:11 AM
Replies: 10
Views: 838
Posted By A. J. Clark

Check that the power wires are in the proper...

Check that the power wires are in the proper orientation.
05-24-2020, 03:36 PM
Replies: 0
Views: 826
Posted By A. J. Clark

RCM Funster as a Twin

I've always wanted a RCM Funster . Just never moved on it. Now that I have had a couple of twins I'm thinking the funster would make a good twin with some mods. I would make the wing fully...
05-23-2020, 01:54 PM
Replies: 1
Views: 686
Posted By A. J. Clark

Test a captured photo

The RCM Funster


https://cimg0.ibsrv.net/gimg/www.rcuniverse.com-vbulletin/400x291/s_l400_34456167455bf20fb1e619f0fb95e97308c298cb.jpg
RCM Funster
Showing results 1 to 25 of 479
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.