I was wondering how much it cost for a new pot to be installed.

Ron

Hi Ron,

The bench charge is $30.00 and hour with a 1/2 minimum, and the parts will be approximately $4.00 or $5.00 per pot.

Please check our website for information on returning items for service and flat rate fees.

http://www.hobbyservices.com/futaba-rates.html

I hope you find this information helpful. You can also reach our Futaba support technical team at 217-398-8970, or via fax at 217-398-7721.

Sincerely,
Krysta
Lead Futaba Customer Service and Programming Technician
Also you may want to check our Website at (http://www.futaba-rc.com)

Thanks for the info.

I have two Zap radios and was wonder if you can make them the same as in centering, trim and a do a tune up.

Ron