RC10GT Tuning Question....
#1
Thread Starter
Junior Member
Joined: Jul 2005
Posts: 24
Likes: 0
Received 0 Likes
on
0 Posts
From: , GA
I'm just figuring out this nitro stuff, except today I flooded the engine because my Glow Starter sucks and always pops off...are there any nice ones that lock on solid for not too much $$$??? Also and the most annoying:
No Matter how the throttle trim is adjusted, it will still roll at least 3 mph when started and when i hold back on the trigger it will slow down to a slow roll but still wont stop!! No reverse either?? I'm confused about this.
Thanks a lot for the help
-nate noob
No Matter how the throttle trim is adjusted, it will still roll at least 3 mph when started and when i hold back on the trigger it will slow down to a slow roll but still wont stop!! No reverse either?? I'm confused about this.
Thanks a lot for the help
-nate noob
#2
There is a Dynamite glowstarter that I have it really locks on solid. About your slow rolling problem. I have an evader and it is pretty much the same I just noticed that my throttle lever that is connected to my carb was out of line is comparison with my carb. It was a little to open so I tightened the screw below and it works. I bet thats a little hard to understand. If you dont understand just ask me.



