Does this look right for a CHRCEXL ignition on a Fuji BT50EI?
06-03-2008 | 08:11 AM
#1
Thread Starter
Member
Joined: May 2008
Posts: 50
Likes: 0
Received 0 Likes
on
0 Posts
From: Newnan,
GA
Does this look right for a CHRCEXL ignition on a Fuji BT50EI?
Hey guys I'm trying to figure out if this looks right. I talked to Terry about whether I had a MK I or MK II engine. I don't know if we got the communication right or what?
As you can see, the hall switch is BEHIND the magnet and not "Facing" the magnet.
I'm confused as to whether this is right or not
So does anyone know? I wanted to send this to CH, but I can't find an email for them
Thanks!
Darrell
As you can see, the hall switch is BEHIND the magnet and not "Facing" the magnet.
I'm confused as to whether this is right or not
So does anyone know? I wanted to send this to CH, but I can't find an email for them
Thanks!
Darrell
06-03-2008 | 09:18 AM
#2
My Feedback: (1)
Joined: Jan 2002
Posts: 3,114
Likes: 0
Received 0 Likes
on
0 Posts
From: Riverton,
WY
RE: Does this look right for a CHRCEXL ignition on a Fuji BT50EI?
Its correct...
The magnet is in the back of your flywheel, the trigger side of the sensor is facing the magnet
The magnet is in the back of your flywheel, the trigger side of the sensor is facing the magnet
06-03-2008 | 09:20 AM
#3
Thread Starter
Member
Joined: May 2008
Posts: 50
Likes: 0
Received 0 Likes
on
0 Posts
From: Newnan,
GA
RE: Does this look right for a CHRCEXL ignition on a Fuji BT50EI?
Hey Terry! Great! Glad to hear it! And thanks! I was going to call you later, but now I don't have to!
Thanks again,
Darrell
Thanks again,
Darrell
