Is there a way to wire servos together for aileron control which will make them operate in opposite directions?
All Day Dan
06-27-2018 08:31 AM
No. Do it mechanically with the servo arms or the mixes in your transmitter.
BarracudaHockey
06-27-2018 08:33 AM
If the model is designed correctly just put them on a y-harness.
rgburrill
06-27-2018 08:50 AM
Originally Posted by BarracudaHockey
(Post 12443285)
If the model is designed correctly just put them on a y-harness.
The plans should show you to connect the pushrods on opposite sides of the servo.
BTW, make sure you put the servo arm on both servos the same way. If you trim off the unused arms make sure you leave on the arms on opposite sides. Most servos have an odd number of splines and if you don't get the arms on correctly they will not be exactly opposite each other and will not have the same travel. It's good to get this all set up and tested before you install the servos.