PLEASE HELP - WALBRO CARB FITTING?
I WANT TO CHANGE THE POSITION OF THE INLET FITTING ON A WALBRO CARB? CAN YOU JUST TURN IT ??? FEELS LIKE SHES GOING TO BREAK - THANKS IN ADVANCE FOR INFO
|
RE: PLEASE HELP - WALBRO CARB FITTING?
Grab it at the base and give it a carefull twist. Try to get it where it needs to be the first time, as the more you move it, the greater chance for leakage.
|
RE: PLEASE HELP - WALBRO CARB FITTING?
It's a press fit. Picture a tight fitting tube within a tube. I mean REALLY tight! Turn it too many times and it'll break. The ones that do happen to come lose usually develop air leaks and your motor runs lean all the time.
Set it and forget it! ;) |
RE: PLEASE HELP - WALBRO CARB FITTING?
use a pair of pliers with sharp teeth and wide enuff to to span the fitting, dont pinch it too tight and give her a twist. if you do break it, you can take the brass insert out and thread in a fuel barb or JB weld a brass tube over it
|
RE: PLEASE HELP - WALBRO CARB FITTING?
THANK YOU ZAC - LIFES - AND OLD - GOT HER TURNED OK NO DAMAGE - WENT ON MAIDEN VOYAGE TODAY - HAD A BLAST - 1ST GAS BOAT - 50" AEROMARINE PRO CAT - THANKS AGAIN ZAC
|
All times are GMT -8. The time now is 11:01 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.