X series Cat
#51
Thread Starter
Join Date: Sep 2010
Location: Staffs, UNITED KINGDOM
Posts: 895
Likes: 0
Received 0 Likes
on
0 Posts
RE: X series Cat
Well made a start on sorting out the power items and hardware also reinforced the transom with another layer of CF
Hoping to get it done real soon and on the water
Once tested ill build the nitro version
#52
Thread Starter
Join Date: Sep 2010
Location: Staffs, UNITED KINGDOM
Posts: 895
Likes: 0
Received 0 Likes
on
0 Posts
RE: X series Cat
Hi Cobus
Check this out
Its still not setup properly and can run a bigger prop so still more to come
http://www.rcuniverse.com/forum/m_11222897/tm.htm
Check this out
Its still not setup properly and can run a bigger prop so still more to come
http://www.rcuniverse.com/forum/m_11222897/tm.htm
#56
Thread Starter
Join Date: Sep 2010
Location: Staffs, UNITED KINGDOM
Posts: 895
Likes: 0
Received 0 Likes
on
0 Posts
RE: X series Cat
Hi Cobus
Not at the minute weather been pretty bad and trying to extend and sort out workshop so i got more room
The moulds are ready for next hull and materials cut etc ready but a sudden change in cooler temps require me to install heating etc so pretty busy at mo
hopefully wont be long and ill be in full swing and popping them out LOL
Not at the minute weather been pretty bad and trying to extend and sort out workshop so i got more room
The moulds are ready for next hull and materials cut etc ready but a sudden change in cooler temps require me to install heating etc so pretty busy at mo
hopefully wont be long and ill be in full swing and popping them out LOL