question...
 

I have a nitro hammer...and today as I was getting it ready for Sundays run...I accidently lost the pin that holds the Hatch
to the rest of the body...

Where I do get another to replace it ?

Also I just used the one thats hold the lid to the servo box...will this be a problem while I am running it ???


Regards,


Winged Avenger

RE: question...
 

I think that all it uses is a body clip/hitch pin that the R/C car guys use so your LHS ought to have them in stock. Mine sells them for a dime apiece.

RE: question...
 

try to get the same size one,i didnt and i had to "special fit" it

RE: question...
 

You drilled the hole out didn't you!:D

RE: question...
 

WA, just make sure don't run ur boat without clip,ur cowling might blown away, it happened already to somebody in this forum.

u can use paper clip for the meantime until u got one.

RE: question...
 

i actually didn't. I am think of just make some small holes with the drill. Also I put the clip that was on the metal servo box to hold
the hatch down. What do think ???

Regards,

Winged Avenger

RE: question...
 

It never hurts to put some foam on the lid anyway for that "just-in-case" time when the hatch might come off like if you flip the boat.

RE: question...
 

im sorry.if a pin is screwin up your day,this is the wrong hobby for you.

RE: question...
 

oh ya i drilled it out. any way i got tired of the peace of junk radio box, may it reast in pieces;)