K&B .91 pushing a 44" cat?
 

Bob is sending me a K&B .91 and i have my aeromarine avenger 44 sitting idle while the QD is being tested in the 52" rigger, will the .91 push the avenger halfway decent?

RE: K&B .91 pushing a 44" cat?
 

Should do around 50. I know the 46" prathers did 50+ with a .82

RE: K&B .91 pushing a 44" cat?
 

We shall see very soon, ill finish the boat this weekend more then likely.

RE: K&B .91 pushing a 44" cat?
 

that motor is rated at 4.8hp. There are .90's that put out near 8hp. It will be interesting to see if it has enough torque for that boat?

RE: K&B .91 pushing a 44" cat?
 

this .91 is a full mod motor, i don't pay any attention to over inflated HP number's. MPH are the only thing i care about and my GPS has yet to lie to me.

RE: K&B .91 pushing a 44" cat?
 

Hay BBmodss is that the black cat you post on the gas form your talking about????[&:]

RE: K&B .91 pushing a 44" cat?
 

well i own 3 cats, bout to be 4, I have a brushless meanmachine, a Aeromarine Avenger 44" cat and a PI 72" cat its the avenger im talking about.

RE: K&B .91 pushing a 44" cat?
 

It's the black one you posted on the gas form!!:D Thats my next boat a cat!! I'm sick and tired that most of the time I cant run my boat in the lake because it's choppy!![:@] Hay would you still be intersted in doing up a sportwerk.26 motor for me???[&:]

RE: K&B .91 pushing a 44" cat?
 

Iv moved on from sportwerks motor's, Axial 32's make better platforms for building. This is the cat your talking about right? http://youtube.com/watch?v=usxwOL7gF34

RE: K&B .91 pushing a 44" cat?
 

or was it this boat? It kinda looks black-ish in the pic. http://sincitytrader.com/Uploader/fi...newcat0021.jpg

RE: K&B .91 pushing a 44" cat?
 

That the boat!!!:D Well how good are you with the axial .32???[&:]Whats the specks on them??[&:]

RE: K&B .91 pushing a 44" cat?
 

The axial 32 can be a 3.5hp motor that will last and last. Take it to PM's for any other questions not related to the avenger.

RE: K&B .91 pushing a 44" cat?
 

Link to dyno chart? Otherwise, save your HP claims for the car/truck forums.

RE: K&B .91 pushing a 44" cat?
 

I don't quite get why your replying in a thread that your not offering any useful comments on, further more my motors are known well enough that i don't need to provide dyno chart's for a comment, where did i say there was a 3.5hp motor? I said they CAN be.