RCU Forums - Solinger flywheel

RCU Forums (https://www.rcuniverse.com/forum/)

- Speed - RC Nitro Boats (https://www.rcuniverse.com/forum/speed-rc-nitro-boats-117/)

- - Solinger flywheel (https://www.rcuniverse.com/forum/speed-rc-nitro-boats-117/9871901-solinger-flywheel.html)

siberianhusky

07-18-2010 09:04 AM

Solinger flywheel

Does the solinger flywheel require the use of a drive washer? The smooth portion of the shaft where the collet goes is pretty short! As is the threaded section once the extension is cut off.
Its an HPI .15 7mm crank 5mm threaded portion. Might go in a JAE 12 if I can get the flywheel figured out!
Soon as this ones done I start on 3 wildthing monos for the "Cottage Racing Team" 3 supertigre marine .18s going in those.

Ron Olson

07-18-2010 11:36 PM

RE: Solinger flywheel

Gotcha covered on the other forum site. Yeah, I'm all over the place! :D

All times are GMT -8. The time now is 04:09 AM.