JR servo opinion for Trex
02-22-2006, 07:41 PM
#1
Senior Member
Thread Starter
Join Date: Mar 2004
Location: St. Louis, MO
Posts: 150
Likes: 0
Received 0 Likes
on
0 Posts
JR servo opinion for Trex
I have a JR radio and gyro and would prefer to stick with JR servos. Should I use something else, and If so is it ok to use with 410 gyro? No 3D stuff, just flyin around.
02-22-2006, 09:20 PM
#2
Senior Member
My Feedback: (2)
Join Date: Jun 2003
Location: Pickstown, SD
Posts: 178
Likes: 0
Received 0 Likes
on
0 Posts
RE: JR servo opinion for Trex
We have used the JR 281's with great success and they center great and have more torque than the others. For the tail we use either the Fut S9650 or the Airtronics 94761Z, both work equally well we just picked up a new JR digital mocro that just came out but i dont have anything to report on it yet. You can use any of these servos with the 401. We are using the JR G500T and the Futaba 401. Anything else let me know....
02-22-2006, 09:47 PM
#4
Senior Member
My Feedback: (2)
Join Date: Jun 2003
Location: Pickstown, SD
Posts: 178
Likes: 0
Received 0 Likes
on
0 Posts
RE: JR servo opinion for Trex
well we sell them too....but i have never used any of them. If you were going to use a servo like them i would go with the Hitec HS56 or HS65's
