need some collective help
 

hey everyone . i have had a cx and a cp rtf and now im assembling a mx 400. im trying to set up the radio . i have a futaba 7uap pcm and a futaba 6 channel reciever. i have the manual for the tx but it is very vague (or should i say very technical ) but i cant figure out which channel to use for the collective pitch servo. this is my plane controller and is geared towards that but there is a heli preset as well.in the manual it looks like its using the 2>6 mix toggle for the idle up mode . any help out there?

RE: need some collective help
 

if i am correct it uses channel 6 and then you have to set up throttle and pitch curves but i dont think your radio is a helicopter radio !!! i am sorry to say ! i would say get the radio that helimax recomends !!! sorry to be the one to brake the bad new !

RE: need some collective help
 

here is the radio i would go with ! reason being im on a very low budget !!! and i am still planning on getting one when i get some extra loot !!!

http://www.heliproz.com/prodinfo.asp?number=151120

RE: need some collective help
 

my tx is not a dedicated heli tx but it has all the program info in the manual but im just too new at this to fully understand it.