Ryobi 28cc Conversion
02-12-2004 | 02:03 PM
#1
Thread Starter
Member
Joined: Nov 2003
Posts: 52
Likes: 0
Received 0 Likes
on
0 Posts
From: Cambridge, CANADA
Ryobi 28cc Conversion
This is short shaft version from a lightly used weed wacker. All mods done at home, no extra purchased parts. Stock ignition.
All tests with an 18x6 Dynathrust prop, unleaded regular gas, and Stihl oil at 32:1.
Stock engine except for cut down flywheel fins............ 5800 RPM. 8.8 lbs thrust.
Stock muffler, gutted, bigger outlet tube..................... 6200 RPM, 10.1 lbs thrust
Above muffler, plus larger carb from old chain saw ..... 6600 RPM, 12 lbs thrust.
Above muffler, carb, blocked decompression slots ...... 7000 RPM, 14 lbs thrust.
Not amazing numbers, but very inexpensive to buy and operate.
All tests with an 18x6 Dynathrust prop, unleaded regular gas, and Stihl oil at 32:1.
Stock engine except for cut down flywheel fins............ 5800 RPM. 8.8 lbs thrust.
Stock muffler, gutted, bigger outlet tube..................... 6200 RPM, 10.1 lbs thrust
Above muffler, plus larger carb from old chain saw ..... 6600 RPM, 12 lbs thrust.
Above muffler, carb, blocked decompression slots ...... 7000 RPM, 14 lbs thrust.
Not amazing numbers, but very inexpensive to buy and operate.
03-09-2004 | 03:39 AM
#2
Member
Joined: Mar 2004
Posts: 44
Likes: 0
Received 0 Likes
on
0 Posts
From: BadajozBadajoz, SPAIN
RE: Ryobi 28cc Conversion
Good moorning!
I apologise my ignorance, but what are "blocked decompression slots"
I love mechanics, so you can speak to me with confidence. Perhaps my problem is the correct translation to spanish.
Thanks, very much
I apologise my ignorance, but what are "blocked decompression slots"
I love mechanics, so you can speak to me with confidence. Perhaps my problem is the correct translation to spanish.
Thanks, very much
