Ttx850 ch5-ch8 set
#1
Junior Member
Thread Starter
Join Date: Aug 2002
Location: Alton,
IL
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
Ttx850 ch5-ch8 set
Page 14 of the manual has a section called:
SPEED: When a control input for channels 5 through 8 is deflected, the speed at which the device connected to that channel moves can be custom set.
My question is, what is the range in seconds covered from full speed 100% down to some value > 0%. If speed is set for 10%, how many seconds will the servo take to rotate from one endpoint to the other endpoint? I would like to slow down flaps and landing gear on two different channels.
SPEED: When a control input for channels 5 through 8 is deflected, the speed at which the device connected to that channel moves can be custom set.
My question is, what is the range in seconds covered from full speed 100% down to some value > 0%. If speed is set for 10%, how many seconds will the servo take to rotate from one endpoint to the other endpoint? I would like to slow down flaps and landing gear on two different channels.