rpm knuckles
04-25-2010, 09:35 AM
#1
Senior Member
Thread Starter
Join Date: Mar 2006
Location: richmond, VA
Posts: 187
Likes: 0
Received 0 Likes
on
0 Posts
rpm knuckles
part number 80035 are not a direct fit for the mgt 8.0. You must order http://www.rpmrcproducts.com/product...s.htm#Setscrew and I can't get the toe out the rear. plus the bearings are thicker and the axle pin is a pain to get to go in. when they came in they said they fit the t/e-maxx. I checked tower and rpms web sites and they are the right parts called for the truck
05-05-2010, 07:02 PM
#2
Senior Member
Join Date: Nov 2005
Location: Orange Park,
FL
Posts: 3,331
Likes: 0
Received 0 Likes
on
0 Posts
RE: rpm knuckles
I ground one side of the pin slightly flat and put that side towards the bearing. It goes in much easier now and doesn't seem to have weakened it.
