Notices
Team RCU - Don Szczur Ask your questions directly to Don Szczur, proffesional pattern pilot

Dual Rates

Old 05-16-2005, 04:15 PM
  #1  
Senior Member
Thread Starter
 
harryw13's Avatar
 
Join Date: Dec 2002
Location: Homerville, OH
Posts: 110
Likes: 0
Received 0 Likes on 0 Posts
Default Dual Rates

Don,
I'm setting up a 87" EF Yak for IMAC, but would also like to do some 3D. By setting up the elevators for 40 degrees of throw, I had to have my low rate at about 25%. Is that to low, will that cause the servo resolution to be to low? The travel Adj. is at 150% (JR 8103). I'm using a spcm rec., with digital servo's. What is the lowest dual rate value I can have, and still have good resolution for precision flying. The servo are is 1 inch.
Thanks
Harry
Old 05-16-2005, 09:26 PM
  #2  
My Feedback: (1)
 
Don Szczur's Avatar
 
Join Date: Jan 2002
Location: Chantilly, VA
Posts: 2,161
Likes: 0
Received 14 Likes on 13 Posts
Default RE: Dual Rates

I'd suggest using th 1 1/4 servo arms, if that will give you your 40 degree throw on the elevator. Then you can dial your ATV down from 150 percent to about 110 to 120 percent. Set your trim resolution to 1 percent after your first flight. As long as your linkages are fairly tight, it should work. I have a similar setup on several of my planes.

Good flying.

Don

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are On


Thread Tools
Search this Thread

Contact Us - Manage Preferences Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.