Go Back  RCU Forums > RC Universe Support > Test Posting Forum
Reload this Page >

How to replate worn trace on printed circuit board

Notices
Test Posting Forum Want to test to see if you can post or test a feature like smilies, avatars or images but don't want to pollute the main forums? Test it out right here.

How to replate worn trace on printed circuit board

Old 01-06-2022, 02:19 PM
  #1  
SPCaudill
Junior Member
Thread Starter
 
Join Date: Jan 2022
Posts: 6
Likes: 0
Received 0 Likes on 0 Posts
Default How to replate worn trace on printed circuit board

I want to know how to replate worn trace on printed circuit board for Radio Shack Radio controlled car 60-4185.
Old 01-06-2022, 08:35 PM
  #2  
mongo
My Feedback: (14)
 
mongo's Avatar
 
Join Date: Dec 2001
Location: Midland, TX
Posts: 3,032
Received 31 Likes on 28 Posts
Default

clean it, lightly abrade it, and use some light gauge wire to make a solder jumper across the bad section

and, for better suggestions, check in the radio related sections of the forum.
Old 01-07-2022, 08:15 AM
  #3  
SPCaudill
Junior Member
Thread Starter
 
Join Date: Jan 2022
Posts: 6
Likes: 0
Received 0 Likes on 0 Posts
Default How to replate worn trace on printed circuit board

Thank you for the suggestion. I will look for radio related sections of the forum for more suggestions. Thank you again.

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.