crashmaster bob

I JUST FINISHED INSTALLING THE SERVOS IN MY V2.
THE INSTRUCTIONS ARE VAGUE AS TO RUNNING THE
WIRES FROM THE SERVOS TO THE RECEIVER IN A
ORDERLY FASHION. ANY TIPS/PHOTOS APPRECIATED.
MY 1ST HELI THAT I COMPLETED(OR NEARLY SO.)
THANKS
BOB

aurin

I dont have a camera but as long as they dont get pulled, cut or worn anyting will do. Tidyness is just for the eye.

On mine V2 i have a boom mounted tail servo so i run all the wire where the tail servo would be. Then zip tie them.

I think its hard to make them look good as you have so many wire running all over the place.

KiwiPilot

Take a wander around your local flying field and see how others have configured their wiring.

As well as cable ties, use cable wrap - as this keeps everything out of sight and much neater than the use of ties alone.

crashmaster bob

Got the wires ran half way decent, nothing getting caught in the servos at least.
I would check the other helis, but in my club their is only 1 other heli flyer, so
I'm kinda on my own. I do have one guy who is going to help me learn to hover.
Thanks

depfife

My Feedback: (14)

Here is my 50 V2.

Eric

FlooredCOBRA

here is my 30 V2

w.pasman

http://graphics.tudelft.nl/~wouter/h...ng/wiring.html