RCU Forums

RCU Forums (https://www.rcuniverse.com/forum/)
-   Tips & Techniques (https://www.rcuniverse.com/forum/tips-techniques-180/)
-   -   throttle servo for Nitroplanes Yak54 (https://www.rcuniverse.com/forum/tips-techniques-180/10458772-throttle-servo-nitroplanes-yak54.html)

voyager_663rd 04-12-2011 12:46 PM

throttle servo for Nitroplanes Yak54
 
Putting this giant scale yak together and one thing I hadn't noticed before: no slot for the throttle servo.

It's the new/original version (one that does NOT have the tunnel and the elev servos are in the fuse, not the stab).

There is a cutout for the (dual) rudder servo(s) but that's it. Anything forward of that is just a uncut piece of ply with no cutouts.

http://img.photobucket.com/albums/v3...d/IMG_0649.jpg

I've seen where one can make a bracket inside the engine box to mount it but I've never encountered this situation b4.

Then again, I've never finished a Nitroplanesbird b4 either.

Suggestions?

pdm52956 04-12-2011 01:56 PM

RE: throttle servo for Nitroplanes Yak54
 
1 Attachment(s)
Lots of ways to build a servo mount. This is what I did on my WH Edge. Pretty simple and quick.

TedMo 04-12-2011 05:03 PM

RE: throttle servo for Nitroplanes Yak54
 
This is called model building.

voyager_663rd 04-12-2011 06:42 PM

RE: throttle servo for Nitroplanes Yak54
 

ORIGINAL: TedMo

This is called model building.
I was going to give you an appropriate reply but momma says you don't have something nice to say, keep quiet.

[:'(]


All times are GMT -8. The time now is 03:07 AM.


Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.