RCU Forums - Correcting Warpped Control Surfaces

RCU Forums (https://www.rcuniverse.com/forum/)

- Tips & Techniques (https://www.rcuniverse.com/forum/tips-techniques-180/)

- - Correcting Warpped Control Surfaces (https://www.rcuniverse.com/forum/tips-techniques-180/7532142-correcting-warpped-control-surfaces.html)

fun2fly

05-23-2008 01:57 PM

Correcting Warpped Control Surfaces

I pulled out a partially built kit I started on awhile ago. Everything seems true except a few of the control surfaces have a slight warp in them. Any suggestions on how to correct this?

Fun2Fly

DavidAgar

05-23-2008 02:26 PM

RE: Correcting Warpped Control Surfaces

If they are covered with Monokote, you can heat up the side that needs to pulled into line. If they need to be covered then you can remove most minor warps as you cover it. Good Luck, Dave

All times are GMT -8. The time now is 08:06 PM.