rEVOkING

works well.

2916jr

what motor mount you using

Danju

oh i just saw your other thread about the tekno brace. and i asked about the side pipe. very neat

rawiswar

yes i was planning on doing this if i have to the picco has not got as much lean on it so the pipe should go straight down by the gearbox let you know if i do this just waiting to know if the mgt pipe is going to be the long or short one as it has the short part number but they dont know if it will be yes the uk is crap for ordering parts lol

rEVOkING

this setup made big top end power.

rEVOkING

someone asked me to post some better pics of the exhaust.

rEVOkING

more

rcnitrohead

That pipe is gonna kill performance, invest in the STS 702 pipe[8D]

So Cal

Looks good!

BRUSHLESS BASHER

rcnitrohead is right, anthing but the 0702 pipe will kill your performance, your probally only getting 50-60% of the power the motor is capeable of with the 0702.

x5t1j

Having a pipe over the fuel tank would make me very nervous!

BRUSHLESS BASHER

^^ that's probally a bad idea too.

bob5429

do you have the 0702 pipe brushless.

rEVOkING

wouldnt want to melt my tanks i might run out of gas.................

HighClassBasher

Me too, plus it kinda clutters up the chassis.... you would have to remove the pipe everytime you cleaned your truck... and i clean my r/cs thoroughly everytime i run them... it just would not work for me.

rEVOkING

actually it is easier to remove than the stock pipe. it actually is better thAN CUTTING UP all my bodys so you can see my exhaust lmao. you cant hit the pipe no matter what.i clean my RC religiously as well and i have no problems remoiving it over and over again. my comment regarding my pipe being over my tank was a joke..lol..this mod kicks ass.

jatoracing33

i would put a heat shield of some sort between the tank and pipe

dirt101

I think the pipe is a composite pipe, so it doesnt put off a whole lot of heat.

rEVOkING

yup.