Go Back  RCU Forums > RC Airplanes > RC Jets > Turbine Clinic
Reload this Page >

Kingtech K45G2 spool up temps

Notices
Turbine Clinic Get direct support from the major turbine manufacturer support reps in here.

Kingtech K45G2 spool up temps

Old 08-16-2022, 07:33 AM
  #1  
[email protected]
Junior Member
Thread Starter
 
Join Date: Nov 2020
Posts: 12
Likes: 0
Received 0 Likes on 0 Posts
Default Kingtech K45G2 spool up temps

Hi there

Need some advice pls. I have a kingtech k45 that Iím a little concerned about.

on the factory settings (column 1) my turbine starts up fine but noticed the temps on startup are pretty high.

At about 25 seconds in after startup the k45 hits 16000 rpm and temps start at this point to hit 1020degrees Celsius and stays at this mark till after 14 seconds later, when at about 31900 rpm range it starts to fall within few seconds to around 600 degrees till the turbine is running.

to get the temps down I have to adjust the pump pw ignite value to below 80 to say 75 to startup with far less peak temps during startup.

the problem is it will never startup if doing a cold start. The turbine will just time out.

any suggestions? Is that normal for a k45 to hit such high temps on startup? Iíve attached the default settings I am using (column 1).







Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright © 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.