RAM T-500 T-750 Modellbau-USA Turbine
 

Hey Everybody!,

Looking for some help finding support or services for Ram T-500 Turbine. I have contacted DreamWorks and George at Jet-Cat they have no available info. once upon a time there was a Carlos at RTI that was in Florida, number disconnected RTI web page for sale. No answer to emails.

looking for possible rebuild information or service.
you can contact me here on RC groups.

67fastlane

T500 turbine....
 

I'm trying to find out if you can use other control modules and pumps to run this tirbine. I have a T500 with less than 2 hours run time.It's never been mounted in a jet.I know it runs perfect,but I hooked up the wrong battery and the ecu stopped working on the start cycle.The start motor and the turbine are all in working condition.

Contact Bob Price 512-897/9770. He's the designer of the Ram ECU, and can repair or replace them.
You could convert it to run on a FADEC but that would be a lot more trouble and expense.

I probably have an extra RAM 500 ECU .

Brian Gates
[email protected]

I am dusting off a RAM 750F that has not run in a few years. Last bench run it was fine. Now it keeps blowing plugs and I think the full 7V voltage is coming to the plug. Any advice on how to trouble shoot this issue? Thanks

Called Bob and he only works on the ECU not the engines themselves.

I have a problem with engine and settings etc, along with no temp reading.

Anyone know's who works on these turbines would be greatly appreaciated.

Regards

Try CRX turbines in New York State.

I have the RAM 750Plus and I can not find the manual, do you have the manual? and what would you charge me for a copy?

Regards
Carlos H

I can get you a copy of my manual but it wont be for approx 2 weeks as I am out of town until then. Let me know if you find one sooner. You might have quicker success by contacting Steven or Dawn Elzey. Send me an email to [email protected] and I can send you a phone number or email for them.