No one makes a King Air kit/ARF?
 

Of all the twins that are available in kit and ARF form I find it hard to believe no one makes a King Air. They have been around since the 60's, are a popular choice for low budget corporate travel and are still produced today.

Back in the day I got my start flying charter in a King Air A90. Today, I'm fortunate to fly a corporate jet full time but recently have been flying some King Airs part time. I had forgotten how much fun they are, especially as single pilot. :D

Does anyone know if there is a kit, ARF or plans available for any King Air model?

RE: No one makes a King Air kit/ARF?
 

http://www.scaleflying.com/COMING-IN...duct_p_52.html

Good luck,

Kor<br type="_moz" />

RE: No one makes a King Air kit/ARF?
 

Check out R/C Aerodyne. They have one that should be out soon if not already

Billy

RE: No one makes a King Air kit/ARF?
 

My friend has 2 in his hangar in Palo Alto Ca., uses them to fly people to ski resorts.

Did mods to the rear of the nacelles to hold skis.

RE: No one makes a King Air kit/ARF?
 

I checked out RC Aerodyne and the King Air is not available yet. I think it may be the same you listed Kor.

I'd like to find something that uses 25 or 40 size 2 strokes. Of all the airplanes out there that are modeled I'm surprised no one has done the King Air. Not even in plans form.

Carlos, that's a nice mod. They're called wing lockers. Great for holding golf bags and soft luggage too.

Thanks for the input everyone!

RE: No one makes a King Air kit/ARF?
 

http://wn.com/rc_beechcraft_b200_king_air_un.org. http://www.rcuniverse.com/forum/js/f...unge_smile.gif



Kor
<br type="_moz" />

RE: No one makes a King Air kit/ARF?
 

I am building a 16ft king air 350 all carbon fiber.I will put this in to a kit around March on April 2013.

RE: No one makes a King Air kit/ARF?
 

WOW! that already sounds out of my league. Are you going to use turboprops?

Here's a link to one I found on youtube. http://www.youtube.com/watch?v=bmoLrO4fC_E

I'm looking for a King Air in the 100+ Inch size. On the other forum there is a guy that does one in foam with CNC, but he'll only start production after he receives 3 orders...
Check the link to get an idea: http://www.rcgroups.com/forums/showp...6&postcount=17

Ben_E