Conversion for non variable pitch rimfire
i have just bought a brushless rimfire motor with out knowing about this new 4D stuff, i can fly 3D with no problem an di would like to give it a try, does anyone here no if they make a conversion kit for my rimfire motor or do i have to buy one that is already made for 4D, thanks for any help
|
RE: Conversion for non variable pitch rimfire
Unless you want to try drilling a hole straight through the motor shaft, nope. However, mamo-models or something like that makes one that is sold through Horizon. Supposedly the best setup out there and it goes around the motor, so it works with any brushless outrunner.
|
RE: Conversion for non variable pitch rimfire
HiĀ“
is it a 3mm shaft or 3,2mm at the rimfire? We have same god pices her in Europe, but we use 3mm shaft only best regards claes www.meijer-models.eu |
RE: Conversion for non variable pitch rimfire
What about the Mamo from Horizon Hobby? Will it fit?
http://www.horizonhobby.com/Products...?ProdID=MAOUSD "it does not require a hollow shaft motor. It will include two set of blades 8" & 9" and will also be selling replacement parts. The most common to replace are (2) 2mm x 12mm screws that are sold by Du-bro in a pack of four." |
RE: Conversion for non variable pitch rimfire
Yup, it should work.
|
RE: Conversion for non variable pitch rimfire
Thanks for finding that guys, I think ill try that out.
|
All times are GMT -8. The time now is 10:07 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.