Notices
Walkera Helis - Dragonfly, etc.. Discuss Walkera Dragonfly Helis and any Walkera products in this forum

Walkera 36 setup

Old 08-01-2010, 12:02 AM
  #1  
chrisd1972
Junior Member
Thread Starter
 
Join Date: Aug 2010
Location: Guateng, SOUTH AFRICA
Posts: 1
Likes: 0
Received 0 Likes on 0 Posts
Default Walkera 36 setup

Hi,

I am helping a friend rebuid his Walkera 36 heli after he crashed it a while back and kind of gave up on RC heli's.

I have replaced main shaft and feathering shaft which were bent and am now busy checking the setup. Rotor head seems to be setup ok, but I am a bit concerned about the rudder.

When I move the rudder stick, the servo only seems to react when I move to the right, and never when I move left from center. Is this maybe a bad gyro? the stock gyro (PL0109-05D) How do I test this gyro?

Also, the servo is mounted on the tail boom at about 45 degrees - is this correct? Can someone maybe send me a photo of the position of the servo, servo horn and ball ?

Also, the transmitter is the stock transmitter (WK-0701) which has 12 dip switches on the back, problem is that the manual that I have and the various posts I have found describe a transmitter with only 10 dip switches.

Any advice on getting this heli bach into flight would be appreciated.

Chris
Old 08-30-2010, 10:12 AM
  #2  
celm
Junior Member
My Feedback: (1)
 
Join Date: Jun 2010
Location: oviedo, FL
Posts: 5
Likes: 0
Received 0 Likes on 0 Posts
Default RE: Walkera 36 setup

cause i bet your in heading hold mode and not rate mode,rate mode will bring servo back to center

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.