Walkera #36 wiring brushless motor
I recently purchased a Walkera Dragonfly 36 and also order the upgrade brushless motor and esc speed controller it is also a walkera but the wiring is different and no diagram. I can see it plugs in to my receiver plugs in to my battery the brush motor had a direct plug out of my receiver......... Not sure how to wire.........Any help??????? thanks
|
RE: Walkera #36 wiring brushless motor
The brushless ESC Rx plug goes to slot/channel #3 on the Rx. The three wires from one end of the ESC (color irrelevent)plug to the three wires on the brushless motor. The Black and red wire on the other end of the ESC go to the battery.
On the Rx, disconnect both the wire that went to the old motor and the one that went to the battery. When using the brushless set-up they are not used. I hope this answers your question. |
RE: Walkera #36 wiring brushless motor
Thanks alot I wasn't sure and the upgrade came with no info..........
that answer my Question........[sm=thumbup.gif] |
RE: Walkera #36 wiring brushless motor
what about the walkera receiver? is it junk?
|
RE: Walkera #36 wiring brushless motor
not sure....Some work some dont, Both on my Walkera #4's work fine. Just do some range checks etc, make sure theres no glitches and all should be fine :)
But you can replace them..... |
All times are GMT -8. The time now is 03:46 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.