Push-rod lengths from swash plate to servo
10-02-2011, 07:43 AM
#1
Member
Thread Starter
Join Date: Apr 2008
Location: Rochester,
NY
Posts: 37
Likes: 0
Received 0 Likes
on
0 Posts
Push-rod lengths from swash plate to servo
I bought a EXI 450 and I also bought the metal head assembly and tail assembly. I find the push rod lengths between the swash and the servos all wrong. I checked in the TREX 450 SA ARF manual and they list as below. These numbers are way off also.
Pitch servo[/b] (front right) arm to outer swashplate, one required:
Rod Length 33.0mm C to C Length 46.0mm Overall Length 52.5mm
Elevator servo (rear) arm to outer swashplate, one required:
Rod Length 28.0mm C to C Length 41.3mm Overall Length 46.8m
Aileron servo (front left) arm to outer swashplate, one required:
Rod Length 19.0mm
C to C Length 32.3mm
Overall Length 37.8mm
Am I using the wrong manual
Pitch servo[/b] (front right) arm to outer swashplate, one required:
Rod Length 33.0mm C to C Length 46.0mm Overall Length 52.5mm
Elevator servo (rear) arm to outer swashplate, one required:
Rod Length 28.0mm C to C Length 41.3mm Overall Length 46.8m
Aileron servo (front left) arm to outer swashplate, one required:
Rod Length 19.0mm
C to C Length 32.3mm
Overall Length 37.8mm
Am I using the wrong manual
10-03-2011, 10:27 AM
#2
Senior Member
Join Date: Sep 2010
Location: la puente, CA, UNITED KINGDOM
Posts: 268
Likes: 0
Received 0 Likes
on
0 Posts
RE: Push-rod lengths from swash plate to servo
Would you like to send it back for exchange, but I had to let you know about this, EXI is our brand make is china and align is different.
Eric
Eric
10-04-2011, 04:55 AM
#3
Member
Thread Starter
Join Date: Apr 2008
Location: Rochester,
NY
Posts: 37
Likes: 0
Received 0 Likes
on
0 Posts
RE: Push-rod lengths from swash plate to servo
Thanks Eric. The workmanship on the HEAD is fine, and in time I will work out the lengths. I was hoping for a short cut. Thanks again for your interest.
