RCU Forums

Go Back  RCU Forums > Glow Engines, Gas Engines, Fuel & Mfg Support Forums > Engine Manufacturers Direct Support Forum > YS Engines Support
Reload this Page >

Piston / Sleeve Clearance

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
YS Engines Support Direct support from YS Performance Engines by Dave Shadel

Piston / Sleeve Clearance

Thread Tools
 
Search this Thread
 
Old 10-27-2012, 02:07 PM
  #1  
Four Stroker
Thread Starter
 
Join Date: Nov 2006
Location: , GA
Posts: 356
Likes: 0
Received 2 Likes on 2 Posts
Default Piston / Sleeve Clearance
petec;

What should the piston to cylinder clearance be on small YS engines ? I have pistons that are 0.004" smaller in diameter than the sleeve which gives a whole lot of piston slap (cold). Put a new ring in and the engine didn't run worth a crap.

Thank You;
Four Stroker is offline  
Reply Like
Old 10-28-2012, 05:38 AM
  #2  
petec
My Feedback: (58)
 
petec's Avatar
 
Join Date: Jan 2002
Location: Beaver Falls, PA
Posts: 2,078
Likes: 0
Received 3 Likes on 3 Posts
Default RE: Piston / Sleeve Clearance
Which engine? I will have to get that info.
petec is offline  
Reply Like
Old 10-28-2012, 06:08 PM
  #3  
Four Stroker
Thread Starter
 
Join Date: Nov 2006
Location: , GA
Posts: 356
Likes: 0
Received 2 Likes on 2 Posts
Default RE: Piston / Sleeve Clearance
Oh say the YS 70.
Four Stroker is offline  
Reply Like
Back to Subforum
YS Engines Support
View Next Unread
YS DZ140

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



Advanced Search

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.