RCU Forums - Disassembling a YS 61-R Long AR

RCU Forums (https://www.rcuniverse.com/forum/)

- YS Engines Support (https://www.rcuniverse.com/forum/ys-engines-support-197/)

- - Disassembling a YS 61-R Long AR (https://www.rcuniverse.com/forum/ys-engines-support-197/1271332-disassembling-ys-61-r-long-ar.html)

fungcc

11-12-2003 09:14 AM

Disassembling a YS 61-R Long AR

Hi Dave,

My friend has a YS 61-R Long AR that he wants to overhaul and clean. Is there any special care he should take when removing the crankshaft from the crank case? He is concern about damage that may cause to the diaphragm pump that is below the crank; or is it just like any other two strokes?

Thanks.

Clement

Dave Shadel

11-12-2003 10:50 AM

RE: Disassembling a YS 61-R Long AR

It's not necessary but will prevent them from being damaged. If you want to, the crank can be removed without taking the reg and carb off.

fungcc

11-13-2003 03:40 AM

RE: Disassembling a YS 61-R Long AR

Also, what is the factory recommended nitro % for this engine? My friend is using 15% and he want to use 20% or even higher.

Clement

Dave Shadel

11-13-2003 12:45 PM

RE: Disassembling a YS 61-R Long AR

Run any fuel you like. If the engine runs hot or blows plugs, you have too much compression or too much nitro.

All times are GMT -8. The time now is 03:59 AM.